Key Fob for Capristo Remote

Please note the key fob design may differ from the picture while functionality and pairing process remain the same. To Add a New Key Fob to the Capristo Programmable CES3 Module: Hold a magnet on the position of the blue dot. Ensure the RC light continues to illuminate. Press button 1 on the key fob. The RC light will disappear. Press button 1 again. The RC light flashes until the new key fob has been stored. The key fob is now ready for use. To Add a New Key Fob to the Capristo Standard Remote (Vacuum): Put the magnet on the hidden magnetic switch (the glowing diode shows it's on standby). Push button 1 of the remote control - the diode will go dark as the controller receives the signal. Push button 1 of the remote control for one-second. The diode will start flashing and will go dark once the key fob is trained. A maximum of 10 remote controls can be trained to one control unit. All trained remote controls can be erased by putting the magnet on the magnetic switch for at least 10 seconds - the diode will confirm by flashing once it's properly removed. Repeat the procedure as needed.