Karma Mobile Audio Allure 6 Midbass | 6.5" SQ Midbass Pair

Karma Mobile Audio Allure 6 Midbass Allure Series 6.5" SQ Midbass | Sold as a Matched Pair 6.5" Midbass Woven Kevlar Cone 125W RMS 4 Ohm Cast Aluminum Basket Allure Series The Flagship Allure Midbass The Karma Mobile Audio Allure 6 Midbass is the flagship 6.5 inch driver in the Allure line, designed by speaker engineer Dr. Rishi S. Gurbani and built to anchor the midbass of a serious 2-way or 3-way front stage. It is sold as a matched pair. Rated at 125 watts RMS with a high-pass in place, 87 dB sensitivity, and a 43 Hz resonant frequency, the Allure 6 delivers tight, fast, accurate midbass in a sealed door or infinite-baffle install. This is reference-grade midbass without the reference-grade invoice. Built to Perform Every part of the Allure 6 is chosen for accuracy under load. The result is a driver that stays composed when you push it and disappears into the music when you do not. Woven Kevlar Cone A high stiffness-to-weight cone keeps motion pistonic in the working band and pushes cone breakup well outside it, for clean midbass with low distortion. Sealed / IB Alignment A total Q of 0.47 with a 43 Hz resonance means this driver wants a sealed door or infinite-baffle install, not a ported box. It rewards a solid, deadened baffle. Integrated Butyl Surround A one-piece butyl surround and gasket seals cleanly to the baffle and survives heat cycling in a door far better than a foam ring that turns to dust. Titanium Former, Cast Motor A 25.5mm titanium voice coil former on a cast aluminum basket and a 90mm motor keep the driver thermally and mechanically stable under real power. Power and Crossover The Allure 6 is built to be amplified and filtered. Run it the way it is designed to run and it delivers far more than its raw thermal number suggests. The factory sheet lists 35 watts nominal and 70 watts peak. That figure is the raw driver measured full-range with no crossover, run to its mechanical limit. It is a bench number, not an install number. Behind the 65 Hz 24 dB-per-octave Linkwitz-Riley high-pass this driver is designed to run, the usable rating is 125 watts RMS. Size your amplifier off 125 watts, not 35. High-pass the Allure 6 between 63 and 80 Hz at 12 to 24 dB per octave, matched to how your subwoofer is integrated, and hand off to the tweeter or midrange around 2.5 kHz. Target a clean 100 to 150 watts per channel at 4 ohms. Fitment and Integration The Allure 6 fits standard 6.5 inch locations with adequate depth. Confirm the cutout and bolt pattern against your factory or adapter ring before install. Overall flange: 166mm. Baffle cutout: 145mm. Bolt circle: 157mm, six holes. Mounting depth: 74.5mm (2.93 in). Overall depth: 80mm. Build the full Allure front stage 2-Way Front Stage Pair the Allure 6 with the Karma Mobile Audio Allure 1 Tweeter for a clean, full-range two-way. 3-Way Front Stage Add a dedicated midrange for the lowest distortion in the vocal band and the widest, most precise stage. Active Setup Run the Allure 6 direct off a multi-channel amp and set every crossover and level in your DSP for full control. Passive Setup Wire it through the Karma Mobile Audio Allure Crossover for a simpler install with jumper-set tweeter level. Reference Midbass, Real-World Price Every Karma Mobile Audio Allure 6 Midbass from Audio Intensity is backed by a 2-year warranty and setup help from a working SQ judge. Tell us your vehicle and your goals and we will dial in the right crossover, amplifier, and install. Built on sound quality first.