Jura Capresso OEM Cherry D45X Micro Switch Fix EMPTY GROUNDS/TRAY MISSING Errors

OEM Jura p/n 65676 (also 65361) micro switch (Cherry D45X). If your machine is stuck on "Empty Grounds" or "Tray Missing", then this switch probably is what you need to fix the problem. If you're looking for the ground coffee chute switch, this is also the correct one.  This switch will fit the following machines (and many more Juras - this list is by far not complete): Jura-Capresso: C5, C50, C55, C60, C65, C70, C75, C9, C90, E5, E8, E9, E10, E20, E25, E30, E40, E45, E5, E50, E55, E60, E65, E70, E74, E75, E80, E85, F5, F50, F55, F7, F70, F9, F90, Impressa Scala Vario, X5, X70, XF50, XF70, Z5, Z6, Z7, Z9, Giga-series Capresso: C1000, C1300, C1500 AEG Cafamosa: CF 80, CF 81, CF 85, CF 90, CF95, CF 100, CF 120, CF 200, CF 300, CF 400, CF 500  The above list is far from complete -- if your machine has a switch labelled D45X, then this switch will of course fit. If your machine has a D41X, it will most likely fit too. See note II below. Note: Some of the older Jura-Capresso S-series and the Capresso C2000/C3000 machines don't use a micro switch for the tray. They use the metal "blades" on the tray to register presence and tray full. In these machines the problem can usually be remedied by cleaning/drying. Make sure the blades on the tray are clean and not oxidized, and that the space between the contacts is completely clean. Use compressed air to blow the contact "fingers" inside the machine clean. Sometimes you will need to remove the fingers for cleaning / replacing them, but usually a thorough clean and let dry will fix the issue. Note II: If your Jura machine has a micro switch, this one should fit even if not listed. Jura uses two different models of this switch in their machines, the D45X and the D41X. The only difference between these switches is the alignment of the three F-connectors. The D41X has these  connector pins straight, and the D45X has them bent. (Using pliers, you can make a D41X from a D45X). Both switches have the exact same body and switch agitator - only the connector pins are different. The D45X will work fine to replace the D41X. However, we only list the machines that actually use the D45X above in order to not to mislead anyone that wants the exact same part. That said, if your JURA machine needs a new micro switch, this one should work fine in any Jura model! (As far as we know, you would not even need to bend the pins in most cases, but there may of course be an exception to this where you may have to straighten the lower pin by pushing it straight in order to make it fit).