Insulated Marine Electrical Bus Bar

This insulated bus bar is an excellent lower-cost option to allow the safe and professional grouping of ground wires in one centralize location on your boat.  You will use this as the connection point for your boat's accessory ground wires. When you are done, only a 10 AWG ground wire from the bus bar and your engine battery cable will be connected negative side of your battery. This will make future trouble shooting a lot easier. This will create less down time fixing marine electrical problems when you should be enjoying your boat.    2" wide and 6 5/8" long 4 - 1/4: studs -Includes 4 #10 screws to secure the marine bus bar to your boat.    Our Story PontoonStuff was founded on the simple idea that boating electrical systems should be simple and you do not need a degree in electrical engineer to rewire your boat. If you are replacing all of our boat wiring or adding a few accent lights this project should be simple and not involve the marina. We limit our offering to make the decision making process easy and painless but offer everything you will need to rewire any type of boat.  We have taken the time to make this project as simple as possible but offering you something you can not buy anywhere else.  We work hard to make your job easy... All Snap Together Marine Electrical System components are lab tested Meet US Coast Guard safety standards by specifying the correct gauge boat wiring so as to minimize voltage drop over the length of every wiring run