Bondtech IFS IDGA Extruder for Prusa Mini or Mini+

In stock, ready to ship.  Comes with the updated Shaft/Gear assembly, as of 2/22/23. New Bondtech Internal Filament Sensor Extruder for Prusa Mini. This extruder is an evolution of Bondtech's previous high-resolution extruder upgrade for the Prusa Mini. Filament Sensor The new filament sensor for Prusa Mini/+ may be mounted inside the extruder housing. The IFS Extruder for Prusa Mini may be used without the filament sensor. With a simple process, it is easy to later update it to fit the Prusa Filament Sensor inside. Upgrade Your Prusa Mini or Mini+ Upgrade your Prusa Mini/+ with a Bondtech Dual-Drive extruder designed to seamlessly fit the original setup. Filament Sensor Compatible The Bondtech Internal Filament Sensor Extruder for Prusa Mini may embed the new Prusa filament sensor for Mini or Mini+ on its housing. The extruder may be used with or without the filament sensor. Hardened Drive Gears Allows the use of abrasive materials that would wear out the gears of your original feeder otherwise. Adjustable tension The thumbscrew tensioner allows the user to fine-tune the pressure exerted by the drive gears onto the filament. This gives you the power to adjust according to your preferences and to optimize for the type of material you are using. Quick-Release To be able to do material changes in a snap, simply activate the Quick-Release lever to release the tension and pull the material to be changed out of the extruder, keep it activated and insert the new material. More choice of materials The hardened steel Dual Drive gears allow you to work with common and abrasive materials. Included in this Kit 1x Bondtech IFS extruder for Prusa Mini 1x 10076-4 IFS Magnet Holder (PA12) 1x 10076-5 IFS Lever (PA12) 1x 15112 IFS Extruder Plug (HT-PLA) 3x Black nylon zip-ties 4x M3x35 black oxide steel screws 1x M3x12 black oxide steel screw 1x Brass motor gear 1x Thumb Screw assembly Not included in this Kit Prusa Filament Sensor Filament Sensor Magnets Filament Sensor Steel Sphere Community Sourced Design The original Bondtech extruder for Prusa Mini design was proposed to us by Olof Ogland. This new IFS version was developed by Vecko Kojchevski on top of Olof’s work. It’s based on the thoroughly tested BMG (Bondtech Mini Geared) and adjusted to the Prusa Mini original design. Product Info EAN Code: 7350011413942 Net weight: 114g Gearing ratio: 3:1 E-steps value: 415 Extruder Housing: SLS Printed parts in PA12; Hinge: injection molded.