ICC 7000 Pro Bright 4 Color Process

FEATURES 700 Series Direct Print Plastisol Inks are engineered with a selection of HP (High Pigment) colors for dark fabrics, standard colors for light fabrics, and a softhand clear (720) that can be mixed with ink to help soften the feel or hand of the print. Well suited for automated equipment although excellent results can be achieved in almost any printing operation. Includes the Pro-Brite™ CMYK series inks 4-COLOR PROCESS SPOT FLASHING The 700 Series inks will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used.  In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift-off, but not totally fused.  Total fusing any flashed color may cause inter-coat adhesion problems with the inks printed on top of the flashed ink.  Final fusing or curing should occur in the dryer. IMPORTANT INFORMATION Use an underbase print when printing 700 Series inks onto dark fabrics or fabrics containing polyester.  Use 711, 7014, 7031 or 7041 white as an underbase ink. To achieve a softer hand and faster production speeds, print underbase ink through finer mesh counts  (230 to 305 t/in or 90 to 120 t/cm mesh). Adding too much reducer or other additives to the 700 Series inks may cause problems with curing/fusing or increased dye migration. Test dryer temperatures and wash test printed product before and during a production run. RECOMMENDED FABRICS 100% Cotton 50/50 Cotton/Polyester Blends INK APPLICATION 700 Series Colors should be printed without any modifications ADDITIVES If modification is necessary, use 1% to 3% by weight of 1110 Curable Reducer for the standard inks SCREEN MESH Four Color Process Colors: 230-305 monofilament EMULSION Any direct or indirect emulsion  or capillary film in the 35 to 70  micron range, depending on the opacity desired SQUEEGEE 65-70 Durometer Sharp edge CURE TEMPERATURES 325°F (163°C) entire ink film CLEAN-UP Any eco-friendly plastisol screen wash STORAGE OF INK CONTAINERS 65º to 90ºF (18ºC to 32ºC) Avoid storage in direct sunlight Keep containers well sealed