Hypertherm Smart SYNC 4ft 45° Head w/50ft Lead Hand Torch (528118)

Hypertherm's SYNC technology allows the power source to communicate with the SmartSync torch and cartridge, thus increasing productivity. The one piece Sync cartridge replaces Hypertherm's traditional five piece setup, thus reducing consumable confusion and optimizing consumable life. Sync systems contain an end-of-life consumable detection on the torch and the power source, letting the user know when to properly change the cartridge. The cartridge also retains its end-of-life status so it can not be re-used improperly. Sync torches can only be used with Sync power sources. Consumables are NOT included and must be purchased separately. Smart Sync Torch Features Internal Cap Sensor - confirms the cartridge is installed correctly. Cartridge Reader - reads information on the RFID chip and relays it to the power source. LED - visual indicators on the handle show system ready state. 7-Step Amperage LED - allows user to select one of seven preset values. Torch Lock Switch - allows consumable changes without turning off the power supply. Safety Trigger - protects the operator from accidental activation. Fiber Reinforced Handle - ensures long life operation and protection if dropped. Spring Strain Relief - protects the torch lead connection to the torch handle. Abrasion Resistant Torch Lead - protects the lead when being dragged over rough surfaces. End-of-Life consumable detection is disabled when one of the following occur • A Fine Cut hand cutting cartridge is installed • The amperage is set below 40 amps for any type of cartridge • The output amperage is set below 55 amps and no communication between the cartridge and system SYNC Consumable Features • Color Coded Single-Piece Cartridge Consumable (Hand, Mechanized/Stand Off, Gouging, and FlushCut/HyAccess) • Radio Frequency Identification (RFID) • Consumable Life Data Tracking