Hydraulic Steering Lock Clips Gen 2

DD26 Fishing Generation 2 Mean Stops Steering interchangable clips Our new patent pending design allows fitment for hydraulic steering systems with 3.75" and/or 4" of exposed steering rod on each side of the engine and will allow fitment with steering rods with diameters of 16mm, 3/4", 20mm and 7/8".    The way this system works is that the standard steering locks you purchased will come with the 3/4" clips attached already.  Those clips result in a 4" width.   Should you have a hydraulic steering system that has a different width or diameter, you simply can purchase the proper clips for your set up and switch them out at your convenience.   Additional clips come in the following set ups: 16mm diameter providing total unit width of 3.75" 20mm diameter providing total unit width of 3.75" 7/8" diameter providing total unit width of 4" Each of these kits comes with 4 steering lock clips. Fitment of a hydraulic steering lock has NOTHING to do with the ENGINE itself.  So if you have a Mercury Engine it has nothing to do with the steering system.  Its all about which hydraulic steering system you have. A good guide of common fitment is:  (but recommended to measure first) Seastar steering systems - Usually 4" steering locks 3/4" Diameter (most common) (These clips come standard with the DD26 Gen 2 Mean Stops) Seastar extra heavy tournament - Usually 4" steering locks with 7/8" diameter Baystar steering systems - Usually 3.75" steering locks with 16mm Diameter Mercury steering systems - Usually 3.75" steering locks with 20mm Diameter Uflex steering systems - Usually 3.75" steering locks with 20mm Diameter Measure first These second generation clips do not fit first generation mean stops!      WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.