Holybro PM07 Power Module Board (14S)

Holybro PM07 Power Module 14S  Holybro PM07 Power Module 14S – Reliable Power Distribution for Your Flight Controller The Holybro PM07 Power Module 14S is an essential component for supplying clean and stable power to your flight controller. Designed to handle high-power applications, this 14S version replaces the older 12S variant, offering improved performance and reliability. Equipped with dual independent 5.2V power outputs, the PM07 provides redundant power supply to ensure a stable voltage source for your flight controller. It also features built-in current and voltage monitoring via an analog signal output, making it an excellent choice for Pixhawk 6C, Pixhawk 4, and similar flight controllers. With an integrated ESC power and signal distribution for up to 8 ESCs, the Holybro PM07 Power Module 14S is perfect for high-power drone builds. The module comes pre-soldered with an XT60 connector, 12AWG wire, and an electrolytic capacitor, allowing for easy installation and a reliable power supply.   Key Features: ✅ Supports 2S-14S input voltage for versatile power management ✅ Dual independent 5.2V outputs for redundant power to the flight controller ✅ Integrated power & signal distribution for up to 8 ESCs ✅ Pre-installed XT60 connector and capacitor for easy setup ✅ Analog current and voltage monitoring for accurate power tracking ✅ Designed for Pixhawk 6C, Pixhawk 4, and similar FCs ✅ High continuous current rating (90A) with burst capacity (140A)   Technical Specifications:   Electrical Ratings: 🔹 Input Voltage: 2S-14S 🔹 Continuous Current Rating: 90A 🔹 Burst Current Rating: 140A (<60 sec) 🔹 Output: 5.2V & 3A Max 🔹 Voltage Divider: 18.182 🔹 Amperes per Volt: 36.364 Mechanical Specifications: 🔹 Dimensions: 68 × 50 × 10mm 🔹 Mounting Holes: 45 × 45mm 🔹 Weight: 43.8g Compatibility Notes: ⚠️ Not compatible with Pixhawk 5X & 6X (requires a digital power module like PM02D) ⚠️ Pre-installed XT60 plug and 12AWG wire support up to 30A continuous / 60A burst current – upgrade if higher current is needed   Package Includes: 📦 1x Holybro PM07 Power Module 14S 📦 1x 80mm XT60 Connector Wire (Pre-installed) 📦 1x Electrolytic Capacitor: 220uF 63V (Pre-installed) 📦 2x JST-GH 10P Cable 📦 1x JST-GH 8P Cable 📦 2x JST-GH 6P Cable   🔗 Setup guides available for PX4 & ArduPilot in the Holybro Docs.