Green Galaxy Water-Based Ink Kit

After traversing every corner of the Green Galaxy, we've collected the best and most valuable hues into one water-based ink kit. Sustainable, friendly to both printer and planet, and economically priced, Green Galaxy inks are taking the universe by storm. Now you can take home all the colors of the universe. The kit includes 14 water-based Green Galaxy inks. INCLUDED IN KITS Quart kits will have quarts of the colors whereas gallon kits will contain gallons of the following colors: Green Galaxy Asteroid Orange Green Galaxy Light Speed Lime Green Galaxy Proton Purple Green Galaxy Starburst Yellow  Green Galaxy Cosmic Pink Green Galaxy Terraform Green Green Galaxy Galactic Gold Green Galaxy Nebulous Navy Green Galaxy Supernova Blue Green Galaxy Neptune Blue  Green Galaxy Martian Green Green Galaxy Mars Red  Green Galaxy Comet White  Green Galaxy Pitch Black  Green Galaxy Warp Drive Low Cure Catalyst 2oz for Quart Kit 8oz for Gallon Kit GENERAL INFORMATION Ready-to-use print water-based ink for printing on light or dark cotton and other non-dye-migrating fabrics. Can be printed on dark polyester or dye-migrating fabrics with the use of a compatible low-cure catalyst. MESH GUIDELINES Can be used with any mesh between 110-305. STENCIL GUIDELINES We recommend using a water-resistant emulsion like Baselayr Complete. It is recommended to degrease your screens with Baselayr Emulsion Prep. For extended screen life and long print runs it is recommended to post-expose the screens and/or use an emulsion hardener like Baselayr Emulsion Hardener. MIXING INFORMATION This product can be mixed with transparent and covering ink from the AB series. PRINTING INSTRUCTIONS Load the screen with plenty of ink. Flood screen prior to printing. Green Galaxy ink can be printed with a push or pull squeegee stroke. After printing, the flood screen allows ink to sit on top of the image to avoid drying. If the screen clogs or exhibits dry ink in the print, re-flood, and aggressively prints again, this should clear the screen. If it does not clear the screen, spray a small amount of warm water into the stuck areas of the screen and wipe it out with a rag. If you are leaving your screen for an extended period of time be sure to leave your screen flooded completely. If your ink begins to scale over, spray with water to rewet the ink. FLASHING INSTRUCTIONS For flashing, forced air flash is optimal. Flash until dry to the touch. CURING INSTRUCTIONS Printed fabric should be cured for a minimum of 90 seconds at 360°F. Ideally, the printed fabric should be cured for three minutes at 300–320°F. TESTING After printing, perform a stretch test to ensure elasticity. It is always recommended to perform a wash test to ensure proper cure prior to going into production. You may also run abrasion testing to watch for flaking and test adhesion. Increase cure dwell time if testing fails. CLEAN UP Ink should be removed from the screen as soon as printing is completed. General wash-up (on ink that has not dried) can be done with water, though using Aqua Wash is much easier and recommended. For aggressive or dried screens, use Aqua Wash to dissolve the ink and blast out areas of stuck ink with water pressure. STORAGE INFORMATION Keep container(s) tightly closed. Store in a cool, well-ventilated location that is locked. GENERAL SAFETY PRECAUTIONS Do not breathe vapors. Wear protective gloves. Do not eat, drink or smoke when using the product. Wash hands thoroughly after handling. Dispose of this product in accordance with local, regional, national, and international regulations as specified. PRODUCT DATA SHEETS