Gray Ice Ceramic Quart

GRAY ICE CERAMIC (1 QUART) ~ HIGH TEMPERATURE STABLE EXHAUST COATING. LOWER GLOSS DARK CHARCOAL FINISH, WILL HAVE A METALLIC LOOK IN SUNLIGHT AS PICTURED BELOW. GOOD THERMAL/CORROSION RESISTANCE. CERAMIC PRIMER CAN BE USED IN COMBINATION WITH GRAY ICE FOR ADDITIONAL HEAT RESISTANCE. INSTRUCTIONS ON USE: Follow normal ceramic prep procedures. Prior to spraying blast with Black Beauty, Aluminum Oxide, or sand for prep (DO NOT USE GLASS BEAD). Wipe down thoroughly with acetone or MEK only and let evaporate completely. Do not use chemical degreasers/phosphatizers. Place in oven at 450F for 1 hr, remove and let cool. Apply coating with airbrush or .6-.8mm tip touch up gun. This should be done at 35-40 lbs of air pressure. Let parts air dry 30-60 minutes. Recommended cure in oven at 750F for 1 hr OR follow steps 8 & 9. Cure in oven at 450F - 500F for 1 hr. This is a partial cure at 450-500F that will allow the part to be handled for installation. Once parts are installed, take vehicle for a light drive allowing the engine to get up to operating temp for at least 1 hour. The heat from the engine will finish curing the parts at 750F or higher. *Regardless of cure method, do not place parts in an already heated oven as it will cause solvent pop. NOTE:PLEASE CHOOSE UPS AS SHIPPING METHOD. WE CANNOT SHIP USPS ON CHEMICALS.