Ford Bronco Cursive Script Metal Emblem Templates - 2021+ Bronco

Install kit is the only thing available now, please read below for more information Ford Licensed Bronco Cursive Metal Emblems (Modified) NOTE:  We are now only offering the template.  Unfortunately we do not have the personnel to de-pin all these emblems. They can be purchased directly from the manufacturer here:  https://www.dennis-carpenter.com/product_search/?globalfilter%5Bcustom1%5D=&globalfilter%5Bcustom2%5D=&globalfilter%5Bcustom4%5D=&q=c6tz-16098 These Ford licensed products are made to the original Bronco specs.  We have modified them to fit the 2021+ Bronco without drilling.  This makes installation a breeze and your vehicle equipped with the highest quality products emblems available. These were designed for the original Bronco which uses locator pins on the fender.  As most owners do not want to drill holes in their newer Bronco, we have carefully removed these pins so you don't have to. Dimensions:  Approximately 10.5 inches wide and 2.25 inches tall.  They outsize the 6th Gen Heritage badges by 1.5 inches! NOTE:  Originally designed for 1966 Broncos.  We have modified a licensed product from it's original form to make it EASIER to install on a flat surface.  In its original, licensed form, it is not intended to mount on a 6th generation Bronco without modification (either pin removal, or drilling of your fender). Includes 2x Ford official licensed fender emblems ( modified by StickerFab, pins removed) 3M adhesive promoter (removed 6/13/2024) Templates (Driver / Passenger) StickerFab application fluid Comparison INSTALLATION (Please Read) NOTE:  The adhesive is VERY sticky so make sure to test fit and double check your placement before removing the adhesive backing.  Make sure the emblem is not bowed out.  Also make sure the emblem is straight.  While removing pins and transit the emblems can lose their alignment, but are easily to mold back to original position.  View your template.  The letters are not all the same size, but the proper alignment is described in the template. Most vehicles have a rake to them.  Find an alignment you are pleased with.  Then you must base your installation off of your own reference.  Mock up your install before installing.  No warranty is available for your alignment issues so please triple check before finalizing install. FAQ What happens if I fail to match the curve of the emblem and the mounting location (fender)?   This usually happens on the passenger side. If the emblem matches the mounting surface when test fit, it will adhere properly with no separation. Do not use force during test fitting to make it fit. If you notice any gap when test fitting, STOP and bend the emblem gently to match the surfaces. Then re-test.  Updated Method (10/27/2023) 75-85 degree weather (not heated garage) recommended.  Maintain 70+ degrees for first 24 hours. NOTE:  3M Promoter has been removed from the setup.  It was causing the adhesive to create a stronger bond to the paint than the vehicle. (6/13/2023) Notice of Non-Affiliation and Disclaimer: Notice of Non-Affiliation and Disclaimer: StickerFab is not sponsored by, affiliated with, endorsed by, or otherwise associated with Ford Motor Company, Ford Performance, or their affiliates.