StickerFab Fog Light Overlays for 4Runner (2025+)

For those who love the look of yellow or amber fog lights, these Fog Light Overlays are a simple and effective way to change the appearance and color output of your factory fogs. Designed specifically for the 2025+ Toyota 4Runner, these overlays add subtle styling while maintaining a clean OEM-plus look. Available in multiple material options, including the new Version 2 snap-in acrylic design, these overlays are easy to install and fully reversible depending on the version selected. Note Color Output: Deep amber provides the most amber appearance but reduces light output compared to lighter shades. Lamp Compatibility: Not compatible with RIGID fog lamps (Pro / Trailhunter) without modification. Shared Fitment: Fitment is the same for 2024+ Tacoma and 2025+ 4Runner and has been verified. Features Easy Installation: Simple application with minimal tools required. Color Change: Alters fog light output to yellow or amber tones. Subtle Styling: Enhances front-end appearance without permanent modification. Multiple Material Options: Available in vinyl, acrylic, and acrylic V2 snap-in designs. Snap-In Acrylic V2: New version clips securely into place with no adhesive required. Direct Fit: Designed specifically for the 2025+ Toyota 4Runner. Extra Set Included: Sold as a pair with an additional spare set included. Vehicle Fitment Vehicle: 2025+ Toyota 4Runner Note: Fitment matches 2024+ Toyota Tacoma Package Contents Fog Light Overlays: 1 pair (plus extra backup set) Installation Instructions General Preparation Surface Cleaning: Clean lens thoroughly using a wax-free detailing spray. Temperature: Recommended installation temperature is 70°F or higher. Environment: Install in the shade to prevent premature adhesion. Acrylic (Adhesive Version) Clean Lens: Remove all dirt and residue. Test Fit: Verify placement before removing adhesive. Apply Adhesive: Remove backing from side strips only. Secure Overlay: Align carefully and press firmly into place. Finish: Remove protective film. Acrylic V2 (Snap-In Version) Clean Lens: Ensure fog light lens is clean. Install Tabs: Insert bottom tabs first, then press top into place. Secure Fit: Confirm all four tabs are seated behind the bumper cover. Removal: Apply upward pressure on the bumper cover and reverse installation steps. Vinyl Installation Recommended Tools: Microfiber towel Wax-free detailing spray Soapy water or StickerFab Application Fluid Felt-tip squeegee Heat gun or hair dryer (optional) Wet Install: Apply fluid to both vinyl and lens surface to allow repositioning. Positioning: Slide vinyl into place until aligned correctly. Squeegee: Gently push out water and air bubbles. Drying: Allow to dry in sunlight, then recheck edges. Heat (Optional): Light heat may be used on edges—do not overheat.