FingerTech Power LED with Clip - Multiple Colors Available

Most events require clearly visible power indicator LEDs to know if your robot is on or off. These make it easy by plugging right into your receiver! Superbright LEDs are highly visible. Come in six colors: Red, White, Blue, Yellow, Green, and Multi-Color! Includes a panel mount clip for easy installation. Specifications: Voltage: 3mm Superbright LEDs have built-in resistors for operating at 3-12V. (Most receivers will be at 5V.) Colors: Red, White, Blue, Yellow, Green, and Multi-color - heat shrink indicates LED color (Multi-Color is grey) Length: 15cm of 20gauge wire Panel-mount Clip hole diameter: 3/16in or 5mm drill bit Panel-mount Clip panel thickness: 3.8mm (015in) max (thicker panels can be counter-bored to the right size) Weight: 2.3grams (0.08oz) Installation: - Drill a 3/16in (or 5mm) hole in your panel. If the panel is thicker than 5/32in (3.8mm), use a larger drill bit to counterbore the material down to the proper thickness. - Insert the Clip into the panel. - Press the LED into the Clip until it clicks. - Plug connector into your receiver (black Ground wire towards the outside of the case). Note: Most receivers run off a BEC from the main battery (for example, the tinyESC motor controllers supply 5V to the receiver), but if your receiver has a separate battery pack, running this LED off the receiver will *not* indicate if the robot's main power is on or off. In that case, you would need to have an LED wired to your main battery.