FHC HD Square Wall Mount Clamp

Fixed Glass Panel Square Profile Glass Clamp Designed For 3/8"-1/2" (10 mm to 12 mm) Tempered Glass Designed to Secure Fixed Glass Panels for Frameless Shower Applications Requires One 3/4" Dia Finger Notch or Hole Drilled in Glass Commonly used in Residential Bath and Commercial Hotel Applications Gasket Specifications For 3/8" (10 mm) Glass: Use One Thick Gasket On Each Side For 1/2" (12 mm) Glass: Use One Thin Gasket On Each Side Glass Instructions Only use tempered safety glass. To prevent damage to the hinge finish during installation, do not use power tools when installing these hinges. Overview FHC Heavy Duty Square Profile Glass Clamps (Finger Notch Glass Cutout) mount directly to the floor, wall, or ceiling to secure fixed glass panels. Allow a 3/16" (5mm) clearance between the glass edge and wall. Use FHC Tru-Clear silicone to provide a water-tight seal after installation. Care & Cleaning Guidelines For best results, keep the following recommendations in mind when caring for your FHC shower door hardware. Your shower door should be dried daily with a soft towel or cloth to ensure its original finish. Do not use harsh cleaners or chemicals on the hardware, as many of the components are coated with a clear lacquer that will become damaged beyond repair. Always test your cleaning solution in an inconspicuous area prior to cleaning the entire hardware surface. Wipe surfaces clean using a soft, dampened cloth or sponge, and rinse completely with warm water immediately after applying the cleaning solution. Use only small amounts of liquid, gentle, cleaner. Never use abrasive products, sponges, or wire scrub brushes while cleaning hardware.