Fantasy Sex Swing

Black nylon-strap sex swing from Pipedream with padded seat and back panel, two padded leg stirrups, and a steel eyelet-and-spring mount for a doorframe or ceiling beam. Pipedream Fantasy Sex Swing. Hangs from a single eyelet bolt that installs into a wooden doorframe (easy, limits motion) or into a ceiling beam (preferred, more range of motion). Heavy-duty link chain runs from the eyelet bolt down through a torsion spring to a metal support bar, which holds the two padded seat/back supports and two padded leg stirrups. EZ-Open connecting hooks let you assemble and break it down without tools after the bolt is installed. Why this works Single-point hang takes the receiver's weight off both partners' arms and legs, opens up positions that floor-based play can't reach. Padded butt/back supports and leg stirrups distribute weight comfortably. Torsion spring adds bounce on installs under 200 lb; remove the spring for installs over 200 lb. Mounts either in a doorframe (easier, limits range) or a ceiling beam (preferred, full range). EZ-Open connecting hooks make set-up and take-down quick after the bolt is in. The specs Frame: Steel eyelet bolt, heavy-duty link chain, torsion spring, metal support bar Seat / back: 2 padded supports Stirrups: 2 small padded leg loops Hardware: 2 EZ-Open connecting hooks, instruction sheet Pilot hole for bolt: 5/16 inch Weight rating: use the torsion spring under 200 lb; remove the spring over 200 lb What's in the box Heavy-duty steel eyelet bolt, heavy-duty link chain, torsion spring, metal support bar, two large padded butt/back supports, two small padded leg stirrups, two EZ-Open connecting hooks, instruction sheet. Care Wipe the nylon straps and padded supports with a damp cloth and mild soap; air dry. Do not machine wash. Inspect the chain, eyelet bolt, and stitching before every use. Use it for Partner play with a suspended receiver, deeper penetration, oral, hands-free positions, body-weight relief for the giving partner, longer scenes without leg fatigue. FAQ Where do I install it? Two options. In a doorway, drill a 5/16-inch pilot hole on the underside of the wooden doorframe, then screw the eyelet bolt in until all threads are concealed. Doorways are easier but limit range of motion. For full range, find a strong ceiling beam with a stud finder, mark the center, drill the pilot hole, and screw the eyelet bolt in there. Pipedream's caution: once the bolt is installed, do not remove it. What's the weight rating? Pipedream's instruction: use the torsion spring if the load on the swing is less than 200 lb. Over 200 lb, assemble without the spring. During two-person use, account for both partners' weight on the swing at once. What's the support like? Two padded supports cradle the butt and lower back, and two padded stirrups hold the legs. Nylon straps connect everything to the metal support bar. How do I take it down between sessions? The EZ-Open connecting hooks let you detach the chain and the swing body after the bolt is installed, so you can put the swing away while leaving the bolt in place. Is there a safety note? Yes. Pipedream warns: avoid putting hands or fingers near the torsion spring while the swing is in use. Inspect all hardware before each session. Don't exceed the 200 lb torsion-spring rating. How do I clean it? Wipe the nylon straps and padded supports with a damp cloth and mild soap. Air dry. Don't machine wash the swing or submerge the hardware. Is it discreet? All orders from The White Unicorn ship in a plain package. The return label will read TWU or shipping department.