Eversolo AMP-F2

Dynamic Power Detailed Presentation The AMP-F2, developed in collaboration between the Starke Sound team and the Eversolo team, is based on the innovative NS600 module created by the Starke Sound team. It boasts a high sampling rate of up to 600KHz. Simultaneously, it significantly reduces noise and enhances dynamic performance through the newly designed SAPS audio-specific switch power supply. It employs an efficient Class D amplification structure, cou-pled with optimized circuits to maximize audio quality. The AMP-F2 is bridgeable, allowing flexible configura-tion for 2-channel or mono-channel setups when needed. Vigorous Output Bridged Support The AMP-F2 is equipped with Starke Sound's NS600 amplifier module, each channel can output a con-stant 250W RMS (42) @ 1% THD+N. When bridged, it can support up to 450W RMS (22) with THD+N still below 1%. This ability to handle extremely low-impedance loads ensures ample energy even in large and challenging speaker setups, particularly during high-dynamic low-frequency outputs. Accurate Sound    Perfect Experience The NS600 module employs PurePath™ Ultra-HD technology and advanced integrated feedback design, featuring high-speed gate driver error correction functions. This technology achieves ultra-low distortion across the entire audio frequency range, delivering perfect high-end audio quality. PurePath™ Ultra-HD Powerful Power Drive Utilizing a 600W high-efficiency, low-ripple, low-EMI switch power supply, it delivers consistent and powerful output, extremely low noise, enhancing the overall dy-namic performance of the system. Environmentally Friendly Low Power Consumption AMP-F2 has an extremely low standby power (0.5W) and idle power consumption (14W), com-plying with the European Union ErP standards. Aluminum Body Shielding Design Complete self-protection and anti-interference design to avoid disturbances from various electrical environments. One-Touch Activation Seamless Control The AMP-F2 is equipped with standard 12V TRIGGER IN and TRIGGER OUT function, allowing it to be synchronized with other devices that support the standard TRIGGER interface for power on and off, using the USB to TRIGGER adapter cable provided with the AMP-F2, you can connect the USB Type A interface of the DMP-A6 to the TRIGGER IN of the AMP-F2 to achieve synchronization. Specifications Basic Parameters Output Power 145W RMS at 8 ohms (1% THD) 250W RMS at 4 ohms (1% THD) 280W RMS at 4 ohms (1% THD, BTL) 450W RMS at 2 ohms (1% THD, BTL) Gain 21.5dB Channel quantity 2 Amplifier type Class D Frequency Response 10Hz-20KHz - 1dB Maximum output current per channel 16.5A/33A(Bridge) Signal-To-Noise Ratio (SNR) >110dB, "A" weighted at 4 ohm 250W THD 0.003% 10W at 1KHz Input Impedance (XLR) 22ΚΩ Input Sensitivity 2.7V Output terminals 2 pairs beryllium copper binding post custom made by Starke Sound Output Impedance 0.1362(5 Hz to 100 kHz) Minimum load impedance 0.8Ω True balance circuit Yes Heat 65 BTU/hr Power consumption Standby ≤0.5W Idle ≤14W Maximum 900W Control option 12V trigger input & output Cabinet Aluminum (Black) Input terminals 2-Channel RCA Input 2-Channel XLR Input Input Impedance (RCA) 11ΚΩ Size 270x228x80 (mm)