Everlast 82i With CNC Package

Dimensions: 25 in × 9.5 in × 15 in Weight: 53 lb Currently on back order 4 weeks ETA This is a cheaper alternative. However, Hypertherm plasma cutters will give you best cutting quality.  Features & Benefits:  Easy starting with Blow Back Pilot arc allows easy cutting of rusty and painted metals Cuts virtually any type of metal with ease Simple to use torches with inexpensive service parts and consumables Commercial/Industrial class, 60% Duty cycle at 80 amps Clean, smooth cuts and improved consumable life with the new Italian designed iPT 80 torch Blowback start starts arc without the need of High Frequency which can interfere with surrounding electronics Pilot arc improves performance and cutting on dirty, painted, or rusted metals  3 Second pilot arc tip saver feature shuts down pilot arc after 3 seconds of contiuous operation if no cutting is present to prevent premature consumable wear Adjustable post flow control up to 50 seconds to improve consumable and torch life Front air pressure gauge allows quick verification of air pressure Over Current and Duty Cycle protection indicates fault with a dedicated warning/diagnostic light, and shuts down output until condition is resolved IGBT modules improve reliability and performance while reducing overall weight CNC socket and CNC torch for plasma table use.   What's included:    25ft. Italian designed and patented iPT 80 CNC torch with Euro quick-connect central adapter Work clamp with 10ft. cable and DINSE connector Air pressure regulator/water trap (Separate air dryer is required to reduce consumable wear and prevent torch damage) Consumable starter kit   Tech Specs:  Type:  IGBT Voltage/phase:  220/240 V 1 Phase Output Amp/Volt Range:  20-80A/88V-112V OCV:  240V Max Inrush ( I1MAX ) Amps:  @ 240V: 58A Maximum Rated (I1EFF ) Input Amps:  @240V: 45.2A Duty Cycle At Rated Amps/Volts:  60% @ 80A/112V 100% @ 63A/105V Arc Start Type:  Blow Back (Piston type) PilotArc:  Yes Torch Type:  Italian designed iPT 80 machine torch (Hand torch not included) CNC Interface Port:  Yes   Adjustable Post Flow Timer:  Yes Gouging:  Light to Medium Recommended Cutting Air Pressure:  75psi Recommended Compressor Capacity:  7CFM @ 90 psi/60 gallon tank OK-to-Cut Indicator/Low Air pressure safety:  Yes