EPeS Max Flow Low Pressure Regulator

The MaxFlow HPA LP regulator can be used with any standard paintball HPA tank. The recommended input for the MaxFlow regulator (or the tank regulator output pressure) is 850 PSI. The regulator can work even with lower input pressure, but full and correct operation cannot be guaranteed. Do not use input pressure higher than 900 PSI. Instructions for use Tournament Lock model for 3D print *We recommend “TechT Gun Sav” or silicone-based lubricants. WD-40 and similar lubricants, which can damage the gasket, are not suitable! IMPORTANT NOTICE ● Never disassemble the regulator while it is mounted on the tank / under pressure! ● Never fully remove the safety valve setting screw while the regulator is mounted on the tank / under pressure! ● Do NOT use with CO2! ● If the basic 8mm setting screw is below the regulator head level by more than 4 mm (4 turns) when set to the desired output pressure, replace it with the longer 12mm setting crew included. ● All output ports of the MaxFlow regulator can be swapped without deteriorating airflow. ● The regulator can be only used screwed directly to an HPA tank. It will not work with an external ON/OFF valve or another method of connection! ● MaxFlow uses a unique construction and works directly with the opening pin of HPA tanks. Its flawless function depends on the condition of the HPA tank output valve – or more precisely the gasket of the tank opening pin. In case your MaxFlow does not work properly, check the condition of this gasket first.