Ebac FD100 13223BB-US Lumber Dryer – 220V, Up to 7m³ Loads, STC1 Control

FD100 Lumber Dryer for Production Workshops The Ebac FD100 dries up to seven cubic meters of timber per load and brings wood as low as 6% moisture content, which suits stock headed for heated interiors. It runs on 220V power, ships with the STC1 controller, and in normal use needs no supplementary heaters or venting. FD100 13223BB-US Capacity and Cycle Up to 7 m³ per load moves a workshop past hobby volumes into regular production drying Reaches as low as 6% moisture content, the band furniture and flooring need for interior stability No supplementary heaters or venting normally required, which simplifies the chamber and lowers running cost Included STC1 controller runs temperature and proportional timing so the operator sets a cycle and lets it work Low-humidity dehumidification drying brings the load down gradually to limit splitting and degrade 220V supply matches the heavier circuits a busy workshop already runs FD100 Applications and Environments The FD100 fits production furniture and cabinet shops, flooring makers, and small commercial mills that dry their own stock. It sits inside a chamber the user builds and pulls moisture from the air so the timber releases water at a controlled rate. Drying to interior moisture content on site removes the wait and cost of sending wood out to a contract kiln. Specifications Typical Load Up to 7 m³ Target Moisture As low as 6% MC Power Supply 220V / 1-Phase / 60Hz Power (Dryer) 1,100 W Power (Heater) 1,500 W Current 12 A Max Operating Temp 122°F Control STC1 controller (included) Dimensions (H×W×D) 33 × 43 × 12 in Weight 167 lbs Documents FD100 Owner's Manual (PDF) FD100 Specification Sheet (PDF) FD100 Spare Parts List (PDF) FD100 Wiring Diagram (PDF) FD100 Wiring Schematic (PDF)