Ebac DD400-P Desiccant Dehumidifier - DD400P - Low Humidity Control – 197 CFM, 220V

Ebac DD400-P Desiccant Dryer for Construction and Restoration Sites Ebac DD400-P dehumidifier is a wheeled desiccant unit for job sites, cold rooms and industrial buildings that need deep drying. Restoration contractors and facility teams reach for it when they need a low dew point or have to dry air that is close to freezing. It removes about 71.5 pints per day at 27°C and 60% RH and keeps going down to -4°F. Ebac DD400-P Mobility and Job-Site Setup Shock-resistant tyres and a free-standing frame let the 68 lb unit roll across rough ground between rooms and floors. Quick spigot connectors make hooking up the 5" dry air and 4" wet air ducts a short task. Integral humidity sensor: electronic control turns drying on and off around the level you set. PPS rotor with 82% active silica gel: washable, so cleaning it is part of normal service rather than a parts order. PTC heater: holds regeneration heat steady for even moisture removal from start to finish. Epoxy powder-coated chassis: takes knocks, dust and grime on construction sites without the finish breaking down. Dual air inlet: keeps 197 cfm of dry air moving into the space you are treating. Hours run meter: records runtime for job records and service planning. Ebac DD400-P Applications and Environments Construction drying and water damage restoration are the main jobs for this machine. Cold storage and other low-temperature rooms suit it as well, because the desiccant process does not need warm air to pull out water. Industrial and commercial buildings use the Ebac DD400-P for general humidity control, and it fits any area where a low dew point is the goal. Noise is rated at 67 dBA. Specifications Model No. 10640RG-US Height 31" (787 mm) Width 21.75" (552 mm) Depth 19" (487 mm) Weight 68 lbs (31 kg) Voltage 220V Phase 1 Frequency 60 Hz Current 8A Power 1.8 kW Process Airflow - Dry Air 197 cfm (334 m³/hr) Regen Airflow - Wet Air 119 cfm (202 m³/hr) Process Duct Size - Dry Air 5" (130 mm) Regen Duct Size - Wet Air 4" (100 mm) Rotor Wheel Speed 20 rph Noise Level 67 dBA Typical Extraction @ 27°C 60% 71.5 ppd (33.8 L/day) Min Operating Temperature -4°F (-20°C) Max Operating Temperature 104°F (40°C) Documents Spec Sheet Manual