Carb & Choke Cleaner 16oz. Aerosol Can

Sold in sets of 1 Dynatex® Carb & Choke Cleaner is a blend of solvents specifically formulated to dissolve and remove varnish, gum sludge and clean the residue deposited on carburetors and chokes during the normal operation of a motor vehicle or other gasoline engine powered equipment. Super jet spray cuts and removes grease and varnish • Oxygen sensor safe • Improves engine performance • VOC Compliant • Tested in accordance to 75/324/EEC Directive 6.1 Carburetors • Manual and automatic chokes • Linkages • Heat risers • PCV valves GENERAL: Shut off engine while spraying product. For pinpoint application, insert extension tube firmly into spray button. Hold can upright and press firmly on spray button to apply product. If spray gets on paint or plastic, flush off immediately with water to avoid damage. CARBURETORS, CHOKES & LINKAGES: Remove air cleaner. Spray and flush exterior surface of carburetor and linkages, and allow to dry (approx. 30 minutes). When dry, start engine and spray short bursts into carburetor throat, flushing automatic choke valve and throttle (butterfly) plates. If engine stalls, stop spraying and restart it. Increase engine speed slightly until all liquid is drawn off, and then replace air cleaner. PCV VALVES: Disconnect crankcase side of PCV valve. Insert extension tube into open end of valve unit and spray a small amount of product inside. Shake unit several times to make sure check valve is loose. Start engine and again spray into valve several times to completely flush it out. Reconnect PCV valve.