Muldex Edition Dumbboard! - Unsoldered Kit

Custom Dumbboards for the Muldex! Photos Courtesy of @dddpworld Muldex Edition has a few key changes from regular dumbboards 1) Hole Spacing is different! If you’d like to use these for a seperate project, Hole spacing is 35.5mm apart, vs Dumbboard’s standard 34mm. 2)Board size is 42.5x31mm, with the hole centers on both sides 8.13 x 3.56mm spaced from the edges. 3) Different connectoring scheme. 3x 2-pin connectors for Thermistor, Tool Fan, and Part Fan, respectively, 1x 3-pin connector for end stop, 1x 4-pin connector for the extruder motor, and 1x 5-pin connector for a full BLTouch. Features,: 18 low-medium current pins (1.5A/pin) for signal and power delivery (Fans, Motor, Sensors) 1 3A circuit [3A] for the hotend Pinout Fully Labelled Connector Information: Uses Molex Micro-fit 10x2 to connect wherever - Direct Wired in OR to another Dumbboard! Uses Molex KK 254 connectors for signal-out Uses JST VH 3.96mm for high-current circuit All connectors included to connect existing harnesses to board Total connections - Male Headers and Female Connectors included with Crimp pins unless otherwise noted. 3x 2pin Molex KK 254 1x 3pin Molex KK 254 1x 4pin Molex KK 254 1x 5pin Molex Kk 254 1x 20P 10x2 Molex Micro-fit (Female PCB header only) 1x 2pin JST VH 3.96mm