Dumbboard V0.9

Tired of unruly handmade wire bundles? The Dumbboard might not be smart, but it definitely can help you clean up the rats nest going to/from your hotend. This is intended to be a harnessing aid for toolchangers, but can be used on any/all 3d printers to clean up your harnessing. Comes with all connectors and headers - just add a 20pin ribbon cable! This is the first run of the dumbboard. Feedback Welcome - Luke@Lukeslab.online Features: 20 low-medium current pins (1.5A/pin) for signal and power delivery (Fans, Motor, Sensors) 2 high-power circuits (6A each) (hotend, laser) Pinout Fully Labelled Jumper available for using screw post as signal circuit - Lulzbot style conductive probing possible! Useful for automatic tool offset calibration Connectors are common with Duet Boards Mount holes are 34mm apart - Mount Directly on a Hemera! (with spacers) Size: 63.5x28.5mm   Connector Information: Uses Common 20pin 2.54mm Ribbon Cable to connect wherever - Direct Wired in OR to another Dumbboard! https://amzn.to/3aVxusY <- Premade Female-Female cable https://amzn.to/38RrEY0 + https://amzn.to/2Uaj2HI + https://amzn.to/2U71o7N - Make your own perfect length IDC cables! Uses Molex KK 254 connectors for signal-out Uses JST VH for power All connectors included to connect existing harnesses to board Duet Smart Toolboard uses JST VH for power-in making swap simpler for future upgrades! Total connections - Male Headers and Female Connectors included with Crimp pins unless otherwise noted. 3x 4pin Molex KK 254 4x 2pin Molex KK 254 1x 20P 2.54mm Pitch IDC - Header Only 4x 2pin JST VH 396 - these are passthrough, so 2 total circuits.