DrillPump300™

The DrillPump300™ is designed to work with most electrical drills with a maximum speed of 2,800 RPM, with an output of at least 600 W. This water transfer pump is ideal for draining small ponds, fish tanks, small pools, or even a flooded basement. The hose connection is 1/2” and uses any 1/2” hose. The unit pumps up to 300 gallons per hour and is self-priming up to 9 feet. The 3/8” shank on this unit fits all common chucks for most drills. DrillPump300™ Features: Pumps up to 300 gallons (1,300 liters) per hour Self-priming up to 9 feet 3/8” shank on this unit fits all common chucks 1/2″ hose connection Tips & Tricks: The power drill may only be operated in clockwise rotation, never run DrillPump300™ in reverse DrillPump300™ will not turn by hand, this must be chucked to the drill DrillPump300™ must be mounted for proper usage, do not hold in hand The hoses should be in good condition, include a gasket, and be completely tightened for priming After every use apply a small amount of silicone grease. To apply, remove the black housing screws and cover, and put a bit of grease on the housing where the rubber fan blades touch, then reassemble. Any spray lubricants, such as WD-40, are not recommended, as they do not provide sufficient lubrication for this product and can cause damage to the internals of the pump. Do not get the drill wet, or use the drill pump with flammable liquids. The direction of flow is indicated by an arrow on the housing. The delivery rate can be regulated by the speed of the power drill.