MATEKSYS FCHUB 12S V2 PDB

Matek PDB is a quality power distribution board for your X-Class or Cinelifter rig. The new MATEKSYS FCHUB 12S V2 PDB was specifically designed for high power demand setups with 5V 5A and 12V 4A regulators. This PDB is also set up with high precision current sensor up to 440A. Check out the rest of our BECs and PDBs as well as the entire Matek selection!  Features Integrated Current Sensor 70A continuous output Wide Voltage Support High Power Handling Durability Features Dual BEC Outputs 110A burst output ESC Connectivity Compact Design LED Indicators 12V Output 5V Output Specifications PDB Input voltage range: 8~60V (3~12S LiPo) 4x70A continuous, 4x110A burst 4x ESC power /signal/ telemetry pads Current Senor: 440A,  3.3V ADC,  Scale 75 2x LED indicators for 5V, 12V 1K:20K voltage divider built-in JST-SH 8PIN CONNECTOR “V” pad: 12V or VBat voltage selectable G: GND Curr: current sensor signal TLM: for BlHeli32 ESC telemetry S1~S4: ESC signal BEC 5V OUTPUT (5V PAD) Voltage: 5.1 +/- 0.1VDC Continuous current 5 Amps,  Max.6A Short-circuit tolerant (2 seconds) Overcurrent protection & self-recovery BEC 12V OUTPUT (12V PAD) Voltage: 12.0 +/- 0.2VDC (Input voltage >=12V) Continuous current 4 Amps,  Max.5A Input voltage<12V,  Output voltage = Input voltage Short-circuit tolerant (2 seconds) Overcurrent protection & self-recovery SWITCHABLE 12V OUTPUT (SW12V PAD) 12V ON/OFF switchable via PINIO(high/low level) support constant 2A can be use for powering VTX, LED etc. BEC 3.3V OUTPUT Linear Regulator Continuous current: 500mA PHYSICAL Mounting: 30.5 x 30.5mm, Φ3mm Dimensions: 55 x 50 x 6 mm Weight: 21g Includes 1x MATEKSYS FCHUB 12S V2 PDB 1x SH1.0_8pin cable 5cm 2x SH1.0_8pin connectors 1x Capacitor