Diteq DiGard Concrete Hardener/Sealer

Diteq DiGard Concrete Hardener/Sealer DITEQ’s DI-GARD Concrete Hardener/Sealer is a semi-topical coating combining the benefits of a penetrating densifier with a topical abrasion resistant sealer. DiGard comes in a ready-to-use state — do not dilute or mix with other chemicals. When properly applied it will create an abrasion and chemical resistant protective barrier to enhance a polished concrete floor. Features DI-GARD should be used after the concrete slab is polished and treated with the DI-HARD Densifier The DI-GARD should be part of the final process because it will create a barrier coat to resist other chemicals from penetrating or bonding to the surface The DI-GARD barrier coat should be reapplied as needed, typically every 3-5 years Because it is a sealer, be certain to apply a test area in an inconspicuous place to be certain it doesn’t alter the appearance of the slab surface Do not let product freeze Application Be certain the surface is completely clean, dry and the concrete slab has remained over 38°F for over 72 hours Charge a dry microfiber mop with a small amount of the DI-GARD product and use a misting sprayer to lightly mist just enough product for a very thin coat to be spread evenly with the microfiber mop It should be applied at a coverage rate of about 1000 sq-ft per gallon Let DI-GARD dry 1 hour between coats or for 2-4 hours before final burnishing or buffing the surface after the final coat If any coat is applied too thick it will create ridges, streaks and/or visible staining, which will alter the appearance of the slab surface Sizes 1 Gallon Bottle - Part No. 160943 5 Gallon Bucket - Part No. 160944