DELTA-ZFR™

Introducing the DELTA-ZFR™ (Zero Friction Roller), a new trigger system specifically designed for the Gunfighter frame. For years, adjustable guide screws have marred the shooting experience. While crucial in fine-tuning, they often lead to unwanted drag throughout the trigger’s pull and release.  ATTKTX™ set out to engineer a better solution that strategically reduced surrounding friction, while leveraging the Gunfighter's innovations. Ultimately creating a smooth, effortless pull that "glides" within the frame TRIANGULATED DESIGN - Three-point contact bearing configuration LARGE ROLLERS - Inspired by high-performance roller skates, creating an easy to maintain pull SNAP-FIT | O-RING - #006 O-Ring snaps in or can be removed to fit various 3-Way actuator rod diameters  ADJUSTABILITY - Stock screws center in bottom track for vertical slack adjustment COMPATABILITY - Compatible with Gunfighter V1 and V1.5 frames PERFORMANCE BEARINGS - Choose between high quality ABEC-5 or Full Ceramic options GUIDED OPERATION - 304 Stainless Steel V-Grooved tracks cradle matching V-Shaped rollers for a linear pull and release ZERO-DRAG - CNC machined trigger features a profile thinner than the track width, ensuring drag-free side-wall operation SELF-LUBRICATING ROLLERS - Brass rollers' lubricating properties ensure smooth operation overtime OPTIMIZED SEAR SPRINGS - 2 Custom-Made stainless-steel springs for both light and reliable sear/trigger returns ANGLED RAMP - 20° ramp angle over stock for faster sear activation REDUCED WEIGHT - Ultra-machined 6061 T6 Aluminum plate cuts reciprocating mass to only 6g (11g total assembly) compared to the stock 24g FINISH - Customize your build with Factory-Anodized Black and Clear DISCLAIMERS: Raw DELTA-ZFR™ triggers arrive factory tumbled and unassembled, with rollers pre-attached to bearings selected at purchase. ATTKTX™ advises using reputable anodizers for custom anodizing. Apply a small amount of high-strength thread locker (LOCTITE 648 Green) to the bearing ID for securement, ensuring no excess reaches the bearing races. Use UN-CURE™ Debonder to clean any excess thread locker. Raw/un-anodized aluminum parts must be anodized before assembly or use, as they are not intended to provide a factory "silver-like" finish. Factory Gunfighter frame guide screws are usually secured with high strength thread locker and may require adjustment when optimizing the DELTA-ZFR™ track system.  Guide screw adjustment or removal may, but not always require the use of heat, debonders, or alternative methods. ATTKTX™ will not be held responsible for damage to components or anodizing which may occur during this process. The use of a qualified air smith or technician is recommended for installation. Guide screws should be re-secured with lower strength thread lockers upon reinstallation and final adjustment.    ATTKTX™ recommends using UN-CURE™ Debonder for guide screw removal and IC-LOC™ Thread Locker- (Blue) for guide screw reinstallation.