Delfin Pro HEPA 10 HV105 Dry HEPA Vacuum – 10 Gal, 110 CFM, 50 Ft Cord

Pro HEPA 10 HV105 — 10-gallon dry HEPA vacuum for asbestos and lead work The Pro HEPA 10 is the dry pick-up machine in Delfin's Pro HEPA line, built around a 2 HP two-stage bypass motor and a certified HEPA filter for crews collecting asbestos debris, lead dust and construction fines. A 10-gallon blow-molded tank on four plate casters keeps the footprint small enough to work a single room, and the 50-foot cord covers a floor plate without hunting for the next outlet. Compared with the 6-quart backpack in the same line, the HV105 gives up wearability for more than six times the tank volume and a stronger two-stage bypass motor. Delfin HV105 filtration, tank and power layout On a dry abatement machine, the filter sequence and the tool-triggered outlet do most of the work. Tested and certified HEPA filter — 99.97% efficiency at 0.3 microns, with a Dacron filter bag, spacer sleeve and polyester pre-filter upstream so the HEPA element is not the first thing to load up Disposable synthetic filter bag — collected material leaves the machine inside the bag, which keeps the operator out of the debris during disposal Auxiliary 115 V outlet on the motorhead — the switch has a tool position, so plugging a sander or grinder into the outlet runs the vacuum whenever the tool runs and dust is captured at the source 2 HP two-stage bypass motor — 110 CFM and 105 inches of water lift, with self-cooling airflow that keeps motor temperature down through long runs Blow-molded tank on four plate casters — stays stable when it is full and takes knocks that dent a steel drum 50-foot power cord — one outlet covers a large bay, a corridor run or a full apartment turn Five tools in the box — hose, two-piece steel wand, floor tool, crevice tool and round dust brush Pro HEPA 10 applications and environments Abatement and restoration contractors run the HV105 on asbestos and lead-paint cleanup, where Delfin rates the filter for hazardous material collection and the machine exceeds the EPA RRP rule for lead dust recovery. Drywall and concrete crews connect it to sanders and grinders through the motorhead outlet to capture dust at the tool instead of sweeping it up afterward. Facility maintenance teams in warehouses, food plants and school districts use it for overhead cleaning of beams, pipe runs and light fixtures, since the 1.5-inch inlet takes standard wands and the tank rolls between rooms on its own casters. It is a dry-only machine: liquids belong in the wet/dry Pro HEPA 20. Specifications Model HV105 (Pro HEPA 10) Voltage 115 V / 60 Hz, single phase Motor 2 HP, 2-stage bypass, commercial grade Max Water Lift 105 in H2O Max Airflow 110 CFM Suction Inlet 1.5 in Recovery Capacity 10 gallons Application Dry pick-up only Collection Disposable synthetic (Dacron) filter bag, spacer sleeve, polyester pre-filter Filtration Tested and certified HEPA filter, 99.97% at 0.3 microns Tank Blow-molded, four plate casters Auxiliary Outlet 115 V on motorhead Power Cord 50 ft Noise Level 66 dB(A) Weight 38 lbs Compliance Exceeds EPA RRP rule for lead dust recovery Included Tools Hose, two-piece steel wand, round dust brush, floor tool, crevice tool Documents Pro HEPA 10 HV105 Specification Sheet (PDF)