DCS Style Motor Mount 12 Valve Race Throttle Cable Bracket

This kit was designed to simplify the throttle cable assembly on first gen trucks that have been modified to run a p-pump. This kit is designed to visually improve the engine compartment by reducing clutter while drastically reducing the complexity of the 12 valve throttle linkage assembly. It utilizes the stock 94-98 12 valve cable from the accelerator pedal to the engine but replaces all the brackets and rods on the side of the injection pump. It is designed for race applications because it eliminates the cruise control mounting points along with the TV lever on trucks equipped with automatic transmissions. If you plan on running this with an automatic transmission you must have a constant pressure valvebody. We make a kit to securely and safely, manually adjust the TV arm on the transmission. This kit is made out of high quality stainless steel to prevent corrosion or rusting. It can be polished to a near mirror finish. This kit also comes with an upper hole designed to be used as a mechanical fuel kill commonly used in race/pulling applications or on trucks running minimal wiring and electronics. This bolts over the motor mount for trucks utilizing the DCS Cummins Conversion motor mounts or some similarly made mounts. Three of the four motor mount bolts on the driver side need to be removed and replaced with the bolts provided in the kit. The lower rear bolt stays. This kit is made for Cummins conversion trucks and will fit a variety of different motor mounts. If you have any questions on your specific vehicle give us a call.