Damascus Antler Handle Boot Dagger with Stacked Handle

The Damascus Antler Handle Boot Dagger shows a feather pattern down both sides. Chevrons radiate out from a central line in the steel. That pattern takes careful forging to line up evenly. Both edges taper to a centered point in true symmetry. The handle stacks four materials between guard and cap. A brass collar sits first, then a reddish band. Mottled antler follows with its own natural texture. Another brass ring and a silver cap close the run. A dark Damascus cross guard separates hand from blade. Every layer compresses tight around a hidden tang. A tooled leather sheath comes included with a brass snap. Divine Knives forges each blade and stacks each handle by hand. Antler is a natural material with its own figure. No two handles show the same marking. Damascus Antler Dagger at Divine Knives with a feather pattern blade, stacked antler handle, and Damascus cross guard. The History Behind This Damascus Antler Handle Boot Dagger Symmetrical daggers rank among the oldest blade forms collectors pursue. Antler served handle makers for centuries, valued for grip and natural figure. Stacked spacer handles grew from smiths joining brass, horn, and wood offcuts. Feather Damascus itself demands precise folding to align the pattern. Divine Knives brings those traditions into one display-grade piece. Antler Handle Boot Knife Performance Feather Damascus holds a keen edge along both ground sides. The symmetry means there is no flat spine to press a thumb against. That makes this a display and collector piece rather than a work blade. Wipe the blade dry after handling and apply a light coat of oil. Fingerprints show readily on an etched surface, so handle it clean. Specifications Overall Length: 10 inches Blade Length: 5.5 inches Blade Material: Damascus steel Blade Pattern: Feather Damascus pattern Blade Finish: Satin acid-etched finish Blade Grind: Double-edged, symmetrical spear point Handle Length: 4.5 inches Handle Material: Stacked construction with brass collar, reddish band, antler, brass spacer, and reddish section Guard: Damascus-patterned cross guard Butt: Silver cap Tang: Hidden through tang Storage: Tooled leather sheath with brass snap included Type: Fixed-blade collector dagger Stacked Handle Dagger Construction Brass spacers separate each handle section with a bright line. The antler band sits mid-handle where the palm settles. A hidden tang runs the full length under the stack. The silver cap compresses everything tight at the butt. Dry storage keeps the antler and leather stable over time. Best Used For This Collector Boot Knife suits display cases, collections, and gifting to a knife enthusiast. The feather pattern draws attention under case lighting. Its antler band gives every piece a different figure. Order the Damascus Antler Handle Boot Dagger today. A feather blade with a stacked antler handle appears nowhere else here. Every knife ships with secure, tracked shipping and careful packaging. Divine Knives keeps stock limited on this design. Each blade takes real time to fold, forge, and etch. Collectors wanting pattern work often pick this over plain grain. The feather and antler give it lasting appeal. FAQ’s Is the blade real Damascus steel? Yes. The blade is forged from layered Damascus steel in a feather pattern. Is the handle real antler? Yes. The mottled band is natural antler. Every piece carries its own figure. Is this blade sharpened on both edges? Yes. Both edges are ground and sharpened, tapering to a centered point. How is this different from the Bone Single-Edge Dagger? That knife has one edge and a cream bone handle. It runs three and a half inches. This one has two edges and a stacked antler handle. How is this different from the Appalachian Damascus Bowie? Both use stacked handles. That bowie runs seventeen inches with leather washers. This dagger runs ten inches with antler and brass.