CUTEK® Wood Stripper

CUTEK® Wood Stripper is a powerful, easy-to-use paint and coating remover designed for both professionals and DIY users. It effectively removes multiple layers of common wood finishes, including latex paints, stains, varnishes, linseed oils, acrylics, and other film-forming coatings. It can also be used on metal, brick, and masonry surfaces. Formulated to be both effective and safer to use, CUTEK® Wood Stripper is a smart alternative to traditional stripping products that rely on harsh chemicals such as methylene chloride or NMP. FEATURES OF CUTEK® WOOD STRIPPER Powerful Coating Remover Effectively removes old paints and surface coatings from wood, metal, brick, and masonry surfaces. Safer Alternative Formula Does not contain harsh chemicals such as methylene chloride or NMP, making it a smarter choice over traditional strippers. DIY-Friendly & Easy to Use Designed for both professionals and homeowners—no special experience required. Typical Uses Removing paint, stains, and coatings from wood surfaces Stripping coatings from metal, brick, and masonry surfaces STEP 1: PREPARE Before Applying Due to the wide variation in coatings, always test CUTEK® Wood Stripper before starting your project. This will help determine: Required dwell time Amount of product needed Effectiveness on your specific coating Note: Multiple applications may be required for thick, multi-layer coatings or heavy film-forming finishes. Safety & Precautions Review all hazards and safety guidelines in the Safety Data Sheet (SDS) Wear appropriate protective equipment Protect all surrounding surfaces and vegetation Be aware of wind drift during rinsing, especially near vehicles or pedestrian areas Pre-wet and rinse adjacent areas (plants, concrete, asphalt, etc.) before and after use Coverage Approximately 120 sq. ft. per gallon Coverage will vary depending on: Type of coating Thickness and number of layers Application Steps Apply evenly to dry wood using: Brush Roller Paint pad applicator Work the product into the wood grain Allow 30–60 minutes of dwell time Keep the surface wet and active by: Reapplying product as needed Lightly agitating with your applicator Important: The surface may become slippery—do not walk on treated areas Test periodically with a scraper to check if the coating is lifting Start with a small test area (approx. 10 sq. ft.) to refine your technique Removal Once the coating has loosened, rinse thoroughly with a pressure washer (approx. 750 PSI / 50 bar) using a fan tip Do NOT use a garden hose—it is not sufficient Cautions: Avoid damaging wood fibers: Do not use turbo/rotary nozzles Adjust pressure and distance as needed Best practice: Start from the lowest point and work upward Use long, even strokes with the grain Cleaning from the top down can cause the product below to become sticky and harder to remove After Stripping Clean the wood with CUTEK® Wood Reviver to: Neutralize and remove residue Brighten and restore the wood Some woods may develop a raised grain: Light sanding or pad scrubbing may be required Clean-Up & Disposal Clean equipment with: CUTEK® Quickclean, or Soap/detergent and water Dispose of all wash water and materials in accordance with local regulations