CrazyG473 V1.0 AIO 5-IN-1 Flight Controller

CrazyG473 V1.0 AIO 5-IN-1 flight controller built-in UART ELRS and 5.8G OpenVTX Tips: Onboard VTX can only work when battery was plug. And low power of vtx when disarmed was active. So the vtx is very lower nearly 0 power out when drone was not armed, you can change power level value. This the first AIO 5-IN-1 flight controller based on G473 MCU platform from Happymodel, Built-in UART ExpressLRS receiver and OpenVTX better for 65mm 1s Micro FPV whoops.   FC MCU: STM32G473CEU6 Gyro: ICM42688P Blackbox memory: 16MB Sensor: Voltage & Current BEC: 5V, Max. 2A UART: UART 1, UART 2, UART 3 (For RX), UART 4(For VTX) BetaFlight OSD: AT7456E ESC: 5A continuous RX: Serial ELRS 2.4GHz RX antenna: Enameled copper wire 31mm length Receiver firmware target: HappyModel EP1/EP2 2.4GHz RX OPENVTX: 5.8GHz 48 channels, Max. 400mW FC firmware target: CRAZYBEEG473 USB port: SH1.0-4Pin Battery connector: A30 Mounting hole size: 5mm x 25.5mm Weight: 3.8g without pigtail and vtx antenna ESC Power input: 1S Only Current: 5A continuous, 6A peak ESC firmware: V0.21.hex Bluejay Firmware target: A_X_5_96KHz Digital signal protocol: DShot300, DShot600 VTX OPENVTX Firmware Support firmware upgrade by openvtx configurator Output power: PIT/10/25/100/400 Frequency: 5.8GHz 48 channels, with Raceband: 5658~5917MHz Channel SEL: SmartAudio2.1 Modulation type: FM Operating temperature: -10℃~+80℃ Antenna port: IPEX1/U.FL Noted: Visit https://app.betaflight.com and click “select your device” then choose can’t find my USB device, then connect comport and betaflight configurator. Due to firmware target is not available in current betaflight official ,you can download hex file from the below link: Firmware Download: CRAZYG473 4.6.0 betaflight firmware Default factory Dump file: Dump file for CRAZYG473 Betaflight4.6.0