Cobble Coat® H2O Wet - Ready-to-Use Water-Based Paver Sealer

Cobble Coat H2O Wet has been reformulated with the newest technology in waterborne protection for concrete brick pavers. It has a greater durability, ease of application and fast drying characteristics. Cobble Coat H20 Wet is a wet look waterborne sealer designed to provide the dark wet look without the harsh smell or harmful effects of solvent, while still providing excellent UV light protection. Cobble Coat H2O Wet provides stain resistance and is specially designed for DIY use. One coat gives a dark wet look on most surfaces, two coats are recommended to provide a sheen and improved durability. Try before you apply — Shop samples now. Each gallon of Cobble Coat H2O Wet will cover approximately 200 square feet per coat; the 5-gallon container of Cobble Coat H2O Wet will cover approximately 1,000 square feet. Coverage will depend on surface porosity, joint width and method of application. Second coat will take slightly less product. On Bare Surface: One and sometimes two thin coats (2 dry mils) provide the best results on uncoated surfaces. Previously Sealed: One coat is recommended. Do not apply Cobble Coat H2O Wet more frequently than every 12 months to avoid a buildup of sealer. Product Features Eco friendly, Biobased & emits low VOC’s Easy to apply, and better coverage Improved durability Improved hardness and chemical resistance Dries faster Helps stabilize joint sand Helps inhibit algae, weeds and ant hills Single Component, so no mixing or waste Natural biodegradability helps prevent sealer buildup Applications Use Cobble Coat H2O Wet on driveways, patios, pool decks, parking lots, walkways, etc. constructed of: Concrete Pavers Only. Cobble Coat H2O Wet is not recommended for pavers installed over a solid surface or on surfaces where moisture is unable to dissipate. Directions Before You Begin: Surfaces must be clean and free of any contaminants before sealing. Cobble Coat H2O Wet’s performance is directly related to how thoroughly the surfaced is prepared. All grease, oil, and potential contaminates must be removed. Do not apply when the temperature of the air or the surface to be coated is below 50°F. Testing on your surface is always recommended to ensure desired results. Surface Preparation: Brick pavers should be installed a minimum of 28 days before sealing. Read label instructions carefully. Cobble Clean, Cobble Prep & Cobble Oxhide may be used for specific cleaning situations. Mixing Instructions: Stir product, some separation may occur and will easily mix in. Application : Roller: Apply with a 3/8” to 3/4” nap roller cover. Avoid over rolling. Always maintain a wet edge. Do not pool or over apply. Airless Sprayer: Spray by overlapping each pass. Always apply in an even film deposit and maintain a working wet line. COBBLE COAT H2O WET IS NOT RECOMMENDED FOR USE ON SURFACES WHERE MOISTURE IS UNABLE TO DISSIPATE. READ LABEL THOROUGHLY BEFORE APPLYING PRODUCT. Resources Technical Data Sheet (English) Technical Data Sheet (Spanish) Product Sell Sheet