CDi2x300BL

The CDi2x300BL is an analog 2 channel speaker amplifier, that will provide great audio quality on smaller install applications. From the Manufacturer: The CDi DriveCore Series is an evolution in amplification, providing an impressive mix of high-performance; rich feature set, and competitive cost.  Using technology derived from our flagship Installed Sound amplifier (Crown DriveCore Install series), the CDi DriveCore 2|300BL offers streamlined functionality to work in almost any small/medium sized installation such as restaurants, retail stores, and more.  Designed for ease-of-use in a variety of applications, the 2|300BL is a 2-channel amp that includes network control/monitoring, high-level DSP, front-panel interface, and support for driving up to 100Vrms speaker loads without requiring a transformer.  The 2|300BL also comes with BLU link, adding the ability to send and receive channels over HARMAN’s digital audio BUS. The entire CDi DriveCore line comes pre-loaded with JBL speaker tunings to help make installations quicker and easier. Features: DriveCore Technology Crown’s proprietary DriveCore technology eliminates hundreds of components within each amplifier, reducing the variability of component values, increasing reliability, resulting in incredible audio fidelity from an efficient design. Network Control and Monitoring Through Harman’s HiQnet Audio Architect software, the CDi DriveCore can be controlled, configured, and monitored through standard TCP/IQ network. DSP-On-board Digital Signal Processor in each amplifier allows for custom configuration Input Router Input Delay – Up to 1000ms Input Parametric EQ – 8 band Crossover Output Parametric EQ – 8 band Output Delay – Up to 100ms LevelMAX™ Limiter BLU link (BL models only)  Both receive and send channels over HARMAN’s 256 channel, fault-tolerant audio BUS, BLU link Direct Drive 70/100Vrms Output Each output channel is capable of providing either 70V or 100V for high impedance applications. Front-Panel Interface Completely configure the amplifier using an intuitive front-panel interface. GPIO/AUX Port  Recall presets, mute channels, monitor faults, power on/off the amplifier, and more through a combined GPIO/AUX Port.    Specifications: BLU link Yes Channels 2 Sensitivity (for full rated power at 8 ohms) 0.7V RMS Rated Power Output (per channel @ 4 ohms) 300W Analog Input Signal to Noise Ratio (ref. rated power, 100V, 20Hz - 20kHz) at 8 ohms) > 104dB THD (full rated power, 20 Hz - 20 kHz) 0.35% Damping Factor (20 Hz to 100 Hz) > 1000 Frequency Response (8Ω, 20 Hz - 20 kHz) +/-0.5dB Crosstalk (below rated power) 20 Hz to 1 kHz > 80dB Input Impedance (nominally balanced, nominally unbalanced) 20 kΩ balanced, 10 kΩ unblanced Dimensions (inches) (W x H x D) (depth not including 1.3 inch front panel protrusion) 19 x 3.5 x 12.25 Weight 14.56 lbs (6.6 kg) Power Supply Connector Standard IEC type 320 inlet for detachable connector 100 – 240V