Capacitive Touch Slider Wireling

DESCRIPTION Touch can be detected using any of the six individual capacitive touch sensors on the back of the Wireling. With detectability all along the back of the board, sliding motions can be interpreted to add a variety of inputs to your next tiny project! This Wireling features the ATtiny841, a high performance, low-power AVR 8-bit controller that comes with preloaded firmware to perform measurements through I²C. New to Wirelings? Check out the Wireling Overview! Note* 5-Pin Wireling cables not included and sold separately. TECH SPECS ATtiny841 8 KB Flash Memory 512 Bytes SRAM and EEPROM Voltage: 1.7V - 5.5V TinyDuino Power Requirements Voltage: 3.0V - 5.5V  Current: 300µA (Active Mode) 0.1µA  (Power-down Mode) Pins Used A5/SCL - I2C Serial Clock line A4/SDA - I2C Serial Data line Dimensions 10mm x 80mm (.394 inches x 3.15 inches) Max Height (from the lower bottom of Wireling to upper top Wireling Connector): 3.70mm (0.15 inches) Weight: 1 gram (.04 ounces) NOTES You can also use this board without the TinyDuino – modifying the connecting cable by removing the opposite connector and stripping/tinning the wires, you can solder the connector cable to any other microcontroller board of your choice!     DOWNLOADS ATtiny841 Datasheet Design Files Schematic  ATtiny841 Arduino Library Arduino Example Sketch CAD 3D and 2D Files