CABLE - GREEN RIGHT ANGLE LINE-6 EXTENSION JUMPER (reverse polarity)

The Cable-Green Adapter features a right-angle Male Barrel Plug with a larger, 2.5 mm Internal Diameter and reverse polarity. It can be used to power Line 6 Modeler pedals from the Power-All. It can also be used with pedals from other manufacturers such as Electro-Harmonix, Digitech, etc. that have a larger; 2.5 mm pin on their power jack. The C-GN/R offers the following features: 1 x Female Barrel jack to connect to Power-All or other power source (C-M/M & C-BL Cable may be required to connect C-GN to brick-style power supplies) 1 x right-angle Male Barrel plug with 2.5 mm I.D. and reverse polarity to connect to pedals or other cables Spring-loaded male plugs to reduce chance of disconnection 26-gauge Cable with oil-resistant vinyl sheath 12” (approx. 305 mm) Cable length between plugs NEW Lo-Pro™ Plug design offers the smallest plug dimensions possible in order to save space on your pedalboard and to make connection to your pedals quick, easy and efficient SPECIFICATIONS: Female Barrel Jack (1): 5.5 mm O.D.; 2.1 mm I.D. Right-Angle Male Barrel Plug (1): 5.5 mm O.D.; 2.5 mm I.D.; 10 mm barrel length Cable: 26-gauge, OFC with oil-resistant vinyl sheath 12” (approx. 305 mm) Cable length between plugs TIPS: Output polarity of C-GN/R’s Male Barrel Plug will be the opposite polarity of source connected to Female Barrel Jack (i.e. if source is tip-negative, then C-GN/R output polarity will be tip-positive) Connect C-M/M Cable to C-GN/R’s Female Barrel Jack to connect to brick-style power supplies or other sources with Female Power Output Jacks Connect Cable-Red  to female end of the C-GN/R to reverse the output polarity of the Male Barrel plug Use C-Cap to cover unused Male Barrel Plug & prevent short-circuits NOTE: Some pedals that require tip-positive polarity at their power input are actually wired with a positive ground to chassis. Some examples of this are the Fuzz Face & Tonebender and many boutique pedals based on these designs. Pedals with this ground configuration cannot be powered from a series power source (e.g. a Daisy Chain) along with pedals that have a negative ground to chassis. In this case, the GH-1 Ground Hound could be used on the positive-ground pedal to allow it to be powered along with negative-ground to chassis pedals off the same Daisy Chain. Please contact us at info@godlyke.com for more information on this issue. *Sum of current draws of pedals used should not exceed maximum output current of Power Supply.