Blanke Aqua Shield Inside Corner

Blanke Aqua Shield Inside Corner Blanke AQUA SHIELD is a thin waterproofing fabric that can be applied with thin-set mortar to dry, flat, and structurally sound surfaces. Tile can be installed immediately on fabric without the cure time required for liquid-applied products. In addition to waterproofing, the Blanke AQUA SHIELD forms a vapor barrier, making it ideal for steam rooms and saunas. A wide range of convenient accessories is available, such as the Blanke AQUA CORN-I and CORN-A for corners, BLANKE AQUA SA, a self-adhesive tape for a quick, convenient taping of seams, and the BLANKE AQUA SEAL, a waterproof polymer adhesive for sealing seams and preformed corners. Features Lightweight waterproofing fabric No waiting to install tile Superior tensile strength Superior workability Crack isolation properties Suitable for interior and exterior applications Resistant to saline solutions, acids, alkaline solutions, many organic solvents, alcohol, and oils Resistant to micro-organisms, deterioration, and rot Waterproofing walls and floors in bathrooms; showers, saunas, locker rooms and exterior decks, patio, balcony and terraces not over occupied space Instructions for Installing Blanke Aqua Shield Inside Corner The substrate must be clean, flat, dry, and load-bearing. Priming the substrate is recommended Treat drains, pipe surrounds, corners, wall-to-wall connections, and wall-to-floor connections first per directions given in BLANKE AQUA SHIELD Installation Instructions Apply the thin-set to the substrate by using a 1/4” x 3/16” V-notched trowel Press BLANKE AQUA CORN I into the thin-set by using the flat side of the trowel, ensuring 100% contact with the substrate Make sure to press out any air pockets In applications subjected to constant and highly moist conditions, use BLANKE AQUA SEAL waterproofing adhesive to seal the overlapped seams. Flatten out any excess BLANKE AQUA SEAL at the connections of corners and bands Suitable Substrates for Bonding: Plywood, drywall, backer board, cement Technical Data Material: Polyethylene film with a fleece glued to the top and bottom Thickness of the PE Film: approx. 0.2 mm (approx. 0,008 inches) Width/in: 4 inches