Beckett Plaque, Square with cut off corners, Basic Plaque Cookie Cutter

This listing is for a physical cookie cutter. These cutters are sized by area, not length or width. Cutters in the same size category will use about the same amount of dough, though some may be shorter or fatter, and some may be taller and skinnier. See photo example in the listing. Small cutters are usually between 6" to 6.5" in area. Medium cutters are usually between 7.25" to 7.75" in area. Large cutters are usually between 8.5"-9" in area. General sizing information on cutters' longest side: • Small round/square cutters tend to be around 3" • Small rectangular cutters tend to be between 3.25-3.5" • Small long or skinny cutters tend to be between 3.75-4" • Medium round/square cutters tend to be around 3.3" • Medium rectangular cutters tend to be around 3.5-4" • Medium long or skinny cutters tend to be around 4.25-4.75" • Large round/square cutters tend to be around 3.7" • Large rectangular cutters tend to be 4-4.5" • Large long or skinny cutters tend to be between 4.5-5.5" This sizing will change slightly between cutter shapes, but this should give you a good idea -The cookie cutter is 3-D printed with PLA filament. -Cutters are Hand Wash Only in warm, NOT HOT water. Do not use a Dishwasher, and do not soak in hot water. Do not store in a hot area. Cutters can warp if stored improperly or exposed to heat. Please read all shop terms and conditions before purchasing. By purchasing, you are agreeing to the shop's terms and conditions. I do not accept returns or exchanges.