Ford Transit Precut and Drilled Unistrut for Mounting Cabinetry

Looking for a rock solid way to mount your cabinetry to the interior of your van?  Don't trust wood screws, glue, bubble gum, duct tape, or any of the other methods that internet people are suggesting to use? Us either.  Enter unistrut.  We have been using this material to fasten cabinetry in our vans since the very beginning.  We finally standardized everything and manufactured a product that can easy be used by our DIY family (you're welcome).  We have decided to sell these pieces individually so you can mix and match to suit your needs.  Strut nuts can be used with unistrut to mount whatever your heart desires (take that L-track).  These pieces are made from P3300 which is shallow 13/16 x 1 5/8 and uses short spring strut nuts. For a clean finished look on exposed ends, check out our 3d printed Unistrut Trim Caps. There are three unique pieces all sold individually: Ceiling- Full length unbroken 92" sticks with 4 fastening locations that are designed to be bolted into the recommended locations in ribs of the van.  We use one on the driver side and one on the passenger side.  Rear- Designed to bolt into the 4 factory locations in the rear upper and lower passenger and driver sides of the van.  Each piece is 54.5" long and uses 2 of the 4 fastening holes.  The vertical pills are for the upper section and the horizontal pills are for the lower section. A full set would be 4 total (Driver upper/lower, passenger upper/lower). Front-  Designed to bolt into the 2 factory locations in the front driver side of the van.  Each piece is 40" long and uses 2 of the 4 fastening holes.  The vertical pills are for the upper section and the horizontal pills are for the lower section. A full set would be 2 total (Driver upper/lower)   *Sold individually with no hardware provided. *   Also feel free to make this yourself.  Detailed PDF on our downloads page.