Aqua Mix Sealer for Grout

Aqua Mix Grout Sealer As a sealer or grout release for all natural stone surfaces, unglazed tile, porcelain, clay pavers, concrete, brick, masonry, and grout. For interior and exterior use Features Aqua Mix Grout Sealer has an expected wear of up to 5 years Will vary depending on the hardness and texture of the surface, type of area, surface wear, frequency, and type of maintenance products used Weather conditions, harsh cleaning methods, and high-alkaline, acidic, or solvent-based cleaners will affect wear Water-based sealer that resists water, oil, and acid-based contaminants Simplifies maintenance and does not change the appearance of the grout Allows moisture vapor transmission Uses Cementitious sanded and unsanded porous grout joints for ceramic tile installations Effective for interior and exterior applications Application of Product Read the entire label before using it. Apply using a soft-bristle paintbrush or sponge paint applicator NOTE: Be sure to wipe the surface completely dry within 5 minutes of each application using absorbent paper or cotton towels After 2 hours, conduct a test to determine if the surface is completely sealed by applying water droplets to the surface If water is absorbed, apply an additional coat. Wait 2 hours and repeat the test It may be reapplied as needed to grout clean joints Pre-Grout Sealer/Grout Release Porous tiles, such as clay and Saltillo pavers, can be stained by grout during installation Sealing the tile before grouting will make grout removal much easier Apply two coats of sealer according to directions after the tile has been bonded for a minimum of 24 hours, or apply to the front face of the tile before installation Drying Time Allow 30 minutes drying time between coats Ready for surface traffic in 2 hours Keep dry for 12 hours; achieve a complete cure in 24 hours