ANet A8 Bed

The ANet A8 Bed delivers reliable printing performance with your choice of standard or ultraflat surfaces to match your precision requirements. Our ultraflat option ensures superior first-layer adhesion and dimensional accuracy across the entire build platform. Upgrade with high-strength magnets for enhanced bed retention and easier print removal without compromising surface integrity. Built to exacting specifications for seamless compatibility with your ANet A8 printer. Choose the configuration that best suits your printing needs. Our magbeds are a top magnet design bed, meaning that the magnets are slightly below the surface of the magbed.  This gives a very superior holding power, however, it does require a very good quality thick build plate.  The manufacturers of those flex plates use a 0.5mm thick sheet.  Thinner sheets may dimple slightly under the magnet.  A lot of China build plates are not up to the challenge. Now, a word of warning, if you are using an inductive sensor, you WILL have issues leveling your bed if you choose the magbed option.  Our magnets are very strong, and they mess with inductive sensors, some capacitive sensors, and even BLTouch.  If you choose to use BLTouch, you will have to dodge magnets while probing your bed.  We do not provide the coordinates for this, so it will be up to you to figure out. IMPORTANT NOTE: If at any point you decide to remove the magnets, first of all, when reinstalling the screws, turn the screw backwards until you feel the threads in the screw jump the threads in the bed. Once you feel that little bump, turn the screw in until it gets to the "screw stops turning point" with zero strength behind it. Once the screw has stopped turning, tighten it 1/32nd of a turn and NO MORE. Overtightening WILL shatter the magnets.