Alpine Microphone Mount | '07 - '21 Tundra / '14 - '22 Sequoia

Alpine Microphone Mount for 2007–2021 Toyota Tundra / 2014 - 2022 Sequoia We're proud to offer a sleek, factory-style solution for mounting your Alpine aftermarket microphone directly into the OEM headliner console of your 2007–2021 Toyota Tundra & 2014 - 2022 Sequoia. This custom mount keeps your microphone neatly integrated while maintaining crystal-clear voice quality and functionality. Installation Instructions Remove the Headliner Console Steps may vary depending on trim: If your truck has a sunglasses compartment, open it and remove the two T20 Torx screws. Use a plastic pry tool to remove the card holder panel; two more T20 screws will be underneath. For 2007–2013 Tundra, follow the video guide below. For 2014–2021 Tundra & 2014–2022 Sequoia, follow the appropriate video. Disconnect Console Wiring Unplug the main wiring harness connector from the console. Remove Foam Insert Locate and remove the foam insert from the factory microphone port. Install the Microphone into the Mount Push the rounded end of the microphone through the opening of the mount. Ensure the rounded end sits near the bottom of the center mount support. Insert the Mount into the Console With the microphone facing down and legs aligned, insert the mount into the headliner console until it clicks securely into place. Route the Microphone Wire Run the wire from the headliner console toward the rearview mirror. Reinstall the console, pulling any slack toward the mirror. Continue routing the wire along the top of the windshield and down the driver-side A-pillar. Finish by running the wire under the dash to your Alpine head unit. Plug the 3.5mm jack into the appropriate mic port on the back of the radio chassis. Test Functionality Power on the system and confirm the microphone is working properly.