Airtech Studios IBS Barrel Stabilizer Unit (KWA, G&G)

The Airtech Studios IBS Barrel Stabilizer Unit is designed to fit on AEG airsoft guns use drop-down menu to choose which model.  Improve your gun's accuracy and performance!  For ARP9, ARP556 (G&G) and KWA Ronin 6 and TK45 models. Once installed, your gun's performance will noticeably shoot straighter and further with a proven improvement to your groupings. In addition, your gun will immediately operate more silently as the stabilizer closes the hollow void inside suppressor which created echoes during your shots. Perfected centered inner barrel Prevents your inner barrel from swaying before the BB exits No vibration on the inner barrel means that the hop-up spin on the BB will no longer be affected as there is less of a chance of it bouncing inside the barrel before its exits   FAQ: How do I remove the orange suppressor cap? It is recommended to have a local tech to remove the suppressor cap, however in most cases this can be achieved at home with a couple ways of doing so. Some models especially in the US are stuck using an adhesive which may be need to be melted in order to loosen up the glue. Before your attempt, please exercise caution and safety by wear thick protective gloving from the intense heat and preferably with a rubbery texture for better a better gripping on the suppressor cap. You may use a series of tools to create the heat including; dipping into boiling water, heat-gun, hairdryer etc. Expose the suppressor cap with the heat incrementally then attempt twisting the cap off using protective gloving. Repeat with more heat exposure until it twists off easily. Some suppressor caps are more stubborn to remove than others. If you encounter this issue, please contact a local tech where they should be able to take it for you with ease and will normally offer their services at a reasonable price. How does the Barrel Stabilizer improve the consistency of my shots? The gun is purchased standard without any support on the muzzle end of the inner barrel. When shooting & moving there is an excessive amount of vibration and axial movement on the tip of the muzzle before the BB exits. The BBs horizontal trajectory and Hop-up spin would be affected by these factors causing the grouping distance to increase. Installing the Barrel Stabilizer will essentially close these factors improving the consistency while tightening the grouping size. Essentially any part of a airsoft replica that moves or shakes should be securely locked down.