75 PSI MAX COMPRESSOR ADAPTER – DEEP ETCH – NEW – UPGRADED

Achieve Deep Etch Glass Engraving Effects With The The Aero-Etch 75 PSI Max Compressor Adapter   Learn the art of deep etch sandcarving using the Aero-Etch Compressor Adapter and create stunning high-relief glass designs producing precise, professional engraving. Every time. PHOTO COURTESY OF GLASS ARTISAN STEPHEN SHAFFER ***SEE INSTRUCTIONS FOR DEEP ETCH ENGRAVING BELOW*** Aero-Etch Compressor Adapter Features Maximum Pressure: 75 PSI (with SRV75 Safety Release Valve) Dimensions: 3 ¾" H x 10 ¼" L x 3 ⅝" W Weight: 14.7 oz Disposable Water Filter: Captures condensation for cleaner operation. Compatibility: Connect with a ½ HP or greater air compressor for steady, consistent abrasive flow  ⚠️ Air compressor not included, Aero-Etch Abrasive Chamber sold separately. Manual On/Off Valve: Provides full control of airflow. Setup: Mount your Aero-Etch Abrasive Chamber (sold separately) to the top of the Adapter Base and connect it to a ½ HP or greater air compressor for steady, consistent abrasive flow.             Made and assembled in the USA at:           Etchcom, Inc.           Danbury, CT USA           www.etchcom.com    Instructions for Deep Etch Sandcarving Step-by-Step Guide to Achieve Deep Etch Sandcarving Using the Newly Updated Compressor Adapter Attach the Aero-Etch Chamber and Stylus Assembly to the Compressor Adapter. Fill the chamber with abrasive and securely close all openings. Ensure the Adapter Shut-Off Valve (red handle) is in the OFF position. Close the Stylus Toggle to prevent accidental spray. Connect the Adapter to your air compressor. Adjust the air compressor’s outflow valve to 70 PSI. ⚠️ Approaching the 75 PSI level WILL trigger the safety release valve and stop the flow. Control the Flow: Gradually and slowly open the Manual Shut-Off Valve to allow air to flow from the compressor, through the adapter, and into the chamber. ⚠️ Opening the valve too quickly MAY CREATE CLOGGING of abrasive in the internal mechanism or nozzle.  Activate Spray: Open the Stylus Toggle to start the flow of pressurized abrasive stream. Engrave: Carve deep into glass within the 65–75 PSI range for stunning results in seconds. Need Help? Have questions? Contact Us: support@aeroetch.com