ADRO 911 GT3 (992.2) Carbon Rear Bumper Apron Panel

The goal for ADRO's aero program for the 992.2 GT3 wasn't to reinvent the car. It was to make it faster where it counts: more downforce, at minimal drag cost, without disturbing the front-to-rear balance Porsche already tuned in. Every component in this kit earns its place by contributing to that single objective. The rear diffuser runs the full length of the car's underside, with vertical fins that stabilize airflow as it exits behind the vehicle. As underbody air transitions from the low pressure beneath the car back to atmospheric pressure, that expansion zone is where flow separation typically happens — the fins manage that transition by spinning up vortices instead of letting it turn turbulent, protecting the downforce the rest of the underbody worked to create. The fins bolt on individually, so if one gets damaged you replace just that fin rather than the whole diffuser — a practical detail for a part that lives this close to the road. The apron panel completes the look with a finished, factory-integrated appearance. Paired as a complete system, the full 992.2 GT3 aero kit increases downforce by 21% over stock for roughly a 1% drag penalty, based on CFD simulation at 180 km/h (112 mph), while holding the GT3's original front-to-rear balance. In raw terms, that's 244N (55 lbs) of load at that speed — but downforce isn't ballast. It presses the tires into the road without adding weight the car has to carry through a corner or haul down under braking, and it builds with speed, so there's more of it exactly when you're leaning on the car hardest. That's balanced grip you can actually use, with almost no loss of straight-line speed. Measurement Stock ADRO Complete Kit Increase Downforce 1145 N 1,389 N +244 N (Approximately 55 lbs) Drag 1071 N 1,083 N +12 N (Approximately 3 lbs) NOTE: Fits 992.2 GT3 If you drive your GT3 hard — track days, hillclimbs, spirited road work — this kit gives you a serious, balanced step in downforce without upsetting the character Porsche built into the car. It's the ADRO foundation for the newest GT3: engineered properly, and designed to hold the balance that matters while making you faster. Ready to build a GT3 that carries more speed everywhere it matters? See you at the track!