Action Army 40K Short Motor

Brill Armory now carries Action Army motors due to numerous recommendations from customers and technicians. This motor is composed of high quality components that undergo strict quality control. Firstly, The Pinion Gear is fully CNC machined. It is TM-spec and meshes well with most bevel gears. So far, there have been no reports of the pinion gear deforming or breaking. The Pinion Gear is smooth and shows no machining marks that could possibly form a weak point. The Silicon steel armature is also fully CNC machined, and some users have noted that the armature itself is wound and balanced to a higher standard. The Motor Can is precision built and has ventilation holes at the top. The Motor Brushes are silver plated and enlarged for best contact with the armature. In addition, this motor uses high grade ball bearings for the armature. This reduces friction and allows the motor to operate more smoothly. In testing, it was shown that the AAC motors glide more smoothly than similar motors. This can be tested by handling a Long-Type motor and holding the motor tower while spinning the motor base. AAC motors are known for running cool under load. Initial testing showed that AAC motors run cooler than other brands in the same gearbox. Part of this is due to superior armature quality and AAC's commitment to quality control. Note: These motors have a high top speed and are best paired with standard ratio or high ratio gears. Using a high voltage battery in conjunction with high speed (low torque) gears will yield a very high ROF, and will only get faster with a lower TPA. Proper gearbox timing is of heightened importance when running a faster gearbox. Specs: 40,000 RPM on 8.4v Full length: (bottom of endbell to top of pinion) 73.2mm CNC Machined Stainless Steel Armature CNC Machined Pinion Gear Precision motor can w/ plastic endbell Ball bearings N38 Neodymium Magnets Enlarged silver-plated brushes