Acrylic Laser Series Automatic Shifter Frame - 2021+ Bronco Automatic

Acrylic Designed for our automatic shifter overlays (topo) Installs with pre-applied 3M 2021+ Bronco Acrylic Laser Series Automatic Shifter Frame This shifter trim piece is designed to make your overlay install a bit easier.  You can install our overlays on the frame and then mount the entire piece on to your shifter trim. NOTE:  We do not recommend using these frames with any aftermarket knobs.  The height could conflict with those installs. Installation Temperature 70-80 degrees. Clean the surface of the acrylic and use the same install described in the video (see overlay page).  It will be easier to install on the frame than the actual shifter.   This is still a wet install. Do not stretch the material as you do not want it to change shape.  The shape of the frame is a match to the overlay.  Once you get the alignment correct, allow to dry. Once dry, press the vinyl down once more. Then move to the vehicle, clean the install area and test fit the frame.  You will need to slip it over the shifter first and then move it towards the back.  It will be mounted around the GOAT mode dial, so you want to test and make sure the placement doesn't prevent movement. Once you have tested the install, remove the backing and re-install.