3D ACA 500 X-TRA Cut Compound

3D ACA 500 X-TRA Cut Compound is the wool pad version of 3D ACA 510 for shops that prefer and use wool pads when cutting with a rotary polisher. When it comes to polishing paint, THE most important factor is the abrasive technology. Think about it? It is the abrasives that TOUCH the paint first, then the buffing pad. Behind the pad is the tool and behind the tool is the person. FAST cutting compound for removing sanding marks and other serious paint defects like swirls, scratches, water spots and oxidation.  3D ACA 500 X-TRA Cut Compound is specifically formulated for use with wool cutting pads with rotary polishers. Precision engineered (proprietary) Alpha Ceramic Alumina, (ACA) sub-micron abrasive technology. Removes down to P1000 grit sanding marks. Body shop safe – Fresh paint safe – Silicone free! Does NOT contain OSHA regulated Crystalline Silica! - HUMAN SAFE Water-based – No harsh solvents or foul odors! Wipes off easy! – Won’t clog buffing pads –– Competitive pricing. 3D’s Green Earth Technology – Biodegradable, Prop 65 and V.O.C. compliant   Directions: IMPORTANT: 3D ACA 500 cuts fast. Be sure to understand the paint you are working on before starting. This compound was originally developed for working on fresh, custom paint work in body shop situations where the technician knows how much paint is being sprayed onto the panels or entire car body. If you’re a detailer working on customer cars, remember factory paint is thin. Always do a Test Spot and use the least aggressive process to get the job done. Always work on a cool clean surface in the shade. Body Shops – Using a rotary polisher Step 1: Prepare the surface by sanding the paint with the sanding paper of your choice. Step 2: Attach preferred foam or wool cutting pad to backing plate on rotary polisher and set speed setting to low or medium. Step 3: Apply 4-5 dime sized drops of product onto center of face of buffing pad. Press face of pad against body panel, turn polisher on and spread product over area to be worked, about 2’ by 2’. Step 4: Move polisher over paint using a slow to medium arm speed. Monitor defect removal as you buff. Once sanding marks or paint defects are removed, stop buffing and remove any excess product using a clean, soft microfiber towel. Detail Shops/Enthusiasts – Using an orbital polisher NOTE: 3D ACA 500 X-TRA CUT COMPOUND is formulated for and intended to be used with wool pads on rotary polishers. Best results are obtained using this type of tool and pad. Results may vary when used with orbital polishers and microfiber and foam pads. Step 1: Prepare the surface by first washing, drying, and removing any above surface bonded contaminants using detailing clay or a clay substitute. Step 2: Attach preferred foam, microfiber or wool cutting pad to backing plate on orbital polisher and set speed setting to low or medium. Step 3: Apply 4-5 dime sized drops of product onto center of face of buffing pad. Press face of pad against body panel, turn polisher on and spread product over area to be worked, about 2’ by 2’. Step 4: Turn polisher to a medium to high speed and begin making overlapping passes. Move polisher over paint using a slow to medium arm speed. Monitor defect removal as you buff. Once paint defects are removed to your satisfaction, stop buffing and remove any excess product using a clean, soft microfiber towel.   SDS SHEET: 3D ACA X-TRA Cut Compound