Verus Engineering Two Piece Front Splitter - 2015-2021 Subaru WRX / STI

Decrease front end lift for your WRX and STI with our two-piece splitter add-on. By using CFD to aid in the design stage, we were able to balance the car out aerodynamically when in use with our rear diffusers. Produced from a hard plastic, it can withstand small impacts without shattering and is abraded when struck from below. It attaches to chassis and bumper locations via OEM holes and rivet nuts, which are included with the kit. This is a two piece splitter kit and automatically comes with the splitter support rod kit! The street splitter makes downforce, reduces drag, and improves aerodynamic balance. This item is made from single piece units that have flaws but cutting and combining two good halves. This is only available in rare occasions and in limited qty. No add to cart button will be shown if none on hand. Two Piece Front Splitter Decrease front end lift for your WRX and STI with our two-piece splitter add-on. By using CFD to aid in the design stage, we were able to balance the car out aerodynamically when in use with our rear diffusers. Produced from a hard plastic, it can withstand small impacts without shattering and is abraded when struck from below. It attaches to chassis and bumper locations via OEM holes and rivet nuts, which are included with the kit. This is a two piece splitter kit and automatically comes with the splitter support rod kit! Construction Hard Durable Body Stainless Hardware Throughout Rivet nut tool included Design The splitter went through many design iterations before the shape was finalized. Each analysis was done using a half-car analysis since no yaw testing was completed. This is done using symmetry down the centerline of the car. Significantly less computational processing power is necessary when using a half-car model and was the reason behind this design approach. The meshing of the car is done using first a surface mesh and then volume mesh. To find a suitable mesh size for the analysis, a grid convergence study was done. A volume mesh count of 10 million cells was considered within the room of accuracy with the turbulence model. Additional Information Very few companies perform CFD or wind tunnel analysis on any of their aerodynamic pieces. As a consumer you can rest assure that you are receiving a quality component with an engineering analysis that has proven to benefit the vehicles characteristics. For additional information you can find Verus's informative packet here. Featured in Our New Products March 2017 Video